Hello,
I have an 06 340 (8.1L V Drives) after approximately 30 mins on the water, at about 3200 RPM's the alarm sounded with 2 beeps, starboard Check Engine illuminated. Alarm would stop for about two mins, Check Engine would go away and then happen again until I was at Idle. Everything looked...
Hello,
Would anyone have a part # for the wet bar sink drain assembly?
I looked it up in the parts manual but it just lists the sink (1689318) but does not go into any more lower level detail ?
Thanks
Hello,
I have a 2006 340 with MERCRUISER - 8.1L INBOARD (Base) engines. I want to replace the raw water intake strainer baskets. There are a couple different sizes and I could not get a definitive answer from any Sea Ray vendors. I would pull one to measure but both basket handles are broke so I...
Hello, my Galley refrigerator stopped working during my last trip out. I did some troubleshooting today and I wanted to share what I found and maybe get some advise from you experts.
Refrigerator: 340 Sundancer - 1691311 REFRIGERATOR, 3.9CF 12/24V 110/220V 50/60HZ
- Works while on shore power...
I am in the process of replacing all my 2006 340 decals, I have most of them but wanted to see if anyone knows where I can get the Port and Starboard decals/stickers that go under the fuel fill caps on the outside of the boat. This is obviously not necessary but since Im in the middle of doing...
Hello, I just had my 2006 340 Sea Ray taken out of the water for my annual bottom paint, wax, general maintenance. I wanted to replace my worn out anchor Davit rollers but I am having some difficulty sourcing just the rollers, or do I have to buy the whole assembly?. The Sea Ray part # for the...
Hello,
I have a 2006 340 Sea Ray, when I raise the anchor, it pulls in too far and digs into my bow. Its pretty tore up so I was wondering if there is some type of stainless guard I could put on, to both cover the abrasions and also to prevent future wear.
Thanks in advance
Hello, I have a 2006 340 Sea Ray with 8.1L Mercruiser inboards (Ser#0W393229,34). My port motor had been intermittently shutting off after extended Idle periods but I have been able to get it restarted (sometimes with starting fluid) and now it will not start at all. This is a cool fuel system...
Hello,
I have a 2006 340 Sportsman, it has twin 8.1 Mercruiser (inboard) motors. I noticed the port side motor had developed a decrease in oil pressure. Typically, both motors are at ~50 psi @ 3200 RPM's and then drop to about 20-25 PSI at Idle. The port motor started indicating ~20 PSI at 3200...
Hello all,
I am new to this site but wanted to share an issue that I had this weekend and wondered if anyone has had any similar issues or may be able to help.
I recently had my boat hauled out for annual maintenance,(cleaning, Bottom paint, etc...)
I was able to open the engine hatch to...