Search results

For more feedback, you may want to join Facebook group: Sea Ray 36 Sedan Bridge Owners

In the four seasons we have owned our 36DB, I have had to replace the Generator Solenoid, Impeller, and reboot the EPLEX system. My current problem with our generator is the data is not appearing on vessel view. What exactly the problem with your generator?

You're very welcome! please consider joining FB page https://www.facebook.com/groups/5378158468949937/?ref=share_group_link for faster and more helpful informatioin.

Address 260 is N19 Module #31 Address 562 is 428 RSP Module # 32 See above post for locations Download:2008 Sea Ray Bridge 36 parts manual,/Sedan Bridge 36 Parts manual page 99 for locations page 100 for modules and address'

1.The EPLEX system is very sensitive to low battery voltage. If you can verify the batteries are fully charged and the system is not responding, do a hard reboot. Also, if a light is ON when the batteries are turned off, it will remain ON until you turn OFF the light WHILE THE BATTERIES ARE ON...

Just an FYI because I have been asked about module locations in the past.

Thank you JasonP! My pump is pretty loud, do you know of an alternative? Also, do you know if its safe to upgrade to a pump with greater GPM, or higher PSI? (aside from faster water usage)

Anybody know the specs or the brand and model of the fresh water pump, or a good replacement? TIA

I have the same boat- you literally have to lift the stairs up from the bottom step, and the first time I lifted mine took every ounce of strength I had!!!

Just wanted to make sure you have seen the document above "Changing batteries and hard reboot". It goes through the proper sequencing process required to get the Eplex system working after changing batteries. I haven't had to do that yet, but I have heard it is important to follow. Tom

More Eplex documents:

Here are a couple of helpful documents for all Eplex owners:

You sound pretty versed with the Eplex system but just a few tips that may help: 1. Are your batteries Good? I have had problems with my Eplex system with low battery charge. 2. Are your Battery switches on and working? 3. If a light is on, and both Port and Starboard Battery Bank switches...

I found the short table pole, and now that we know what the cushion is for, we'll keep it!

Is there noise present with both shore power lines disconnected?

I do not have factory lights but I installed two Lumitec SeaBlaze X2 lights and wired them to the wires designated for the factory lights and they work great!

I emailed NautiMart support and they told me to pull up the SETUP page on the 350LCD screen above the salon tv by holding down the white tab at the top of any page for 15 seconds. The SETUP page comes up and the HULL soft touch button must be turned on (green) for the rocker switches to work...

Thank you for the reply! I don't recall seeing a short leg but I will check for it next weekend!

Thanks for the pic! Very nice and clean wiring job. I am contacting Sea Ray to find out how to get the underwater light outputs on my module 12 working. That module also controls my engine sync, generator crank relay and generator shutdown relay, all which function properly. So I am thinking...