Search results

I'm in process of replacing bravo one for bravo 3. Got bravo 3 in 'decent' condition, cleaned it, repainted... Just pulled bravo one from the boat and when in neutral on bravo one upper shaft that goes into coupler spins pretty freely, while bravo 3 have some resistance. Since uppers are...

I'm preparing outdrive for painting and noticed that bearing carrier is originally not painted. Since the drive was media blasted, I believe whatever protective coat it had is gone. Is there any reason not to paint it together with the drive? Regarding painting process, idea is following. 1...

Does anyone know if these are much louder then stock manifold/risers? I have them on 270dancer single 7.4 and it's really loud above 3000rpm, it does sounds healthy and I would love the sound on go fast, but it sounds a bit too much for a cruiser. I'm trying to figure out if loudness is coming...

I'm planning to replace these toward the end of season and by searching around figured it either require partial sterndrive disassemble or some people tend to drill hole above the waterline and put wires through it. I have an idea to cut the wires of old sender solder new sender wires on them...

Does anyone know balancer diameter? My doesn't have timing marks and I'm planning to go to the lake tomorrow and check the timing, so want to make timing tape now, but don't know the diameter.

I'm trying to find this out for quite some time without success. In 1999 according to official documentation base 7.4 mpi was paired with B2 and optionally with B3. I know that B2 have longer(sits deeper) lower unit, so Im trying to figure out if they were mounted through the same hole on...

Hi I recently purchased boat from title and it was doing 27-30mph (depending on trim) at 3200rpm WOT, It did run very strong up to 3200 and pained without the problem with 2 person a aboard ( 3/4 gas/freshwater tank). On my last trip on the way back to marina I experienced some misfire, and...