I haven't tried it on water yet, I bought it few months ago. I need to refurbish the full interior before I can put it on water. I sent you my email, the manual would be very helpful!
Hi, I have a Mercury 135 2 stroke that runs just fine in idle:
(or you tell me if this doesn't sound OK.)
Then I give some throttle and the engine dies. (sorry that's not on the video). Not immediately, but after 3-10 seconds, and even if I turn the throttle just a little bit, not even close...
I have a Sea Ray 180 CB made in 1990 and all the interior wood elements need to be replaced. I've found a good upholsterer but I need to create the wood frame elements. Is there any source where I can find the diagrams of the interior elements for the same model? Would make my life easier than...
Thanks everyone, I will try to do it properly with fiberglass and epoxy. I'm only worried about tose holes that are deep because there is a layer of wood behind.
Anyway I will figure out something, at least it doesn't have to look pretty as it won't be visible
Hi,
I have these nasty holes on my Searay and I'm wondering if you can suggest an easy way to fix it. Is there any single component product that I could use or only resin and fibreglass would work? I was looking at sealants like...
@PlayDate this is a picture of the transom:
There seems to be a number below the inboard whole, but not readable from the image. If I find out what that number is, where can I get the details of the boat?
I'm about to buy a Sea Ray project boat - the seller claims it is a Sea Ray 200 srv, however, I can't find any similar images of the type online. In fact when I search for Sea Ray 200 srv, the boats I hit look different. Can anyone recognize this model?
Any info would be much appreciated...