Hi.
I would like a spare tire for my trailer, but i can not see anywhere what the bolt pattern is.. (yes i can see that its a 5 hole..)
Is it 4-1/2", 4-3/4" or 5" how to measure or lookup?
Thanks..
Hi all,
I have two 12v batteries connected to create 24 V, thats fine. I also have some accessories that only uses 12 V. I dont need to use them all at the same time. I also only need 12 V from one of the batteries (not both), which is why the 12c acc. is connected to the neg of one of the...
Hi all.
Yesterday i saw my voltage on the gauge and on my garmin gps showed 17.2v it stayed like that for a minute or two and went back to 14 again. Then it happed a copule of times again. No effect on the engine or any electrical parts. The rpm was between 1000 and 2500 no changes of voltage...
Hi good folks,
This weekend i hit a shallow water before I could get the engine up and the boat out again. Long story short, the engines telltale is very weak/or non existing. Sometimes it comes on and then its off again, irrespective of engine RPM.
I have been running the enigne 2 hours since...
Hi all,
my Quicksilver Commander 3000 control body (remote throttle) is acting weird, especially with the "throttle only" button (wont come out), and I have reviewed all the options, and many parts are not available anymore. So I might have to change the whole remote control body, so my...
Hi all. I have a standard bow rider with the normal benches in front. And I would like to install 2 or 3 rodholders somewhere on the boat. Do you have any suggestion ideas maybe with pictures. Tried Google without any luck.. (I know its not the best fishing boat but I do occasionally fish)
Thanks
Hi all,
I have just installed a new audio system (with 4 speakers, amplifier and bluetooth reciever, as a package). Now the system works perfectly when the ignition is on (and the engine is not started). But today I went out, and to my surprise, it works with a lot of outage when the engine is...
Hi all,
I have a 1996 115 hp Mercury OB, with the plastic speedometer pickup assembly broken.
(see the link if you dont know what it is).
It is a plastic assembly where the thread is also made of plastic that goes into the lower gear, and that plastic is broken (the plastic rectangular piece...