the out rollers on the cable master have two micro switches in series. if one fails it stop going out. my assembly was old and broke when i removed it. replaced the whole collar for $65. go to you tube to see what i am talking about
they have an cylinder overhaul kit. ghs, clearwater. took my cylinders to a local shop and they loved the kit. my cylinders are like new, fast and strong and even on the lift
just bought an 8D AGM battery. opened the top to a cell and the leaf and agm were dry. asked the seller if i add water or electrolyte and he didn’t know. anybody know?
It seems to me that exiting the marina at 190 degrees is too high a temp. Definitely check or change impellers. Flush systems for barnacles and exit marina again. Don’t go over 1000rpm until temp reaches 180 if they are Cummins
I have a 48 SB .at the stern on the starboard is a Glendining 240 volt hookup. On the port is a 240v plug-in. I recently plugged it in when thr glendining was out. Nothing. On the panel, nothing. I traced the wires to where they both connect to terminals in a “transfer box”. Could this be the...
Got my prop off on the hard. In the water the puller was not enough. On the hard the man hit the shaft which sent a vib ration through and the prop came right off. Kinda like tapping a lid on a jar that does not come off. Lesson learned
Need to replace 1 original quad sea ray guage. Fuel is not working on it. Swapped guages and know it is the guage. Can it be repaired? Where can I get one?
I have the analog round quad guages for temp pressure voltage and fuel. The fuel portion is inop. I need to replace or fix the guage. Definitely the guage. Anybody with any ideas? Also the plastic latch for the screen and shade overhead hatch is broken. Where can I find a replacement?