Search results

  1. J

    Eim? Keypad? Fuses?

    I’m having similar issues when I turn on batteries my port keypad lights up then shuts off then blower turns on by itself then if I press trim tab aft acc lights up then fed acc turns blower on etc etc yesterday I pressed blower and heard pop in the fwd rim under helm then all switches where...
  2. J

    TNT switch

    Hey guys I could use some help. My drives are only trimming down on throttle switches and up on trailer. I jumped the soliniods and they go up I think the switch is bad does anyone have a part number it’s twin engine throttle handle switch on a 06 280 sundancer could it be another problem? Both...
  3. J

    Raw water in my shift cable?!?!

    Just replaced motors drive and assembly’s ran motors on ear no issues put boat in started 30 secs later salt water dripping out of shift cable on port motor (cable that goes to drive) bellows are good clamps are tight what the heck is happening?
  4. J

    “Just venting “

    Hey all just need to talk about my boating nightmare...grew up on boats all my life finally decided to get my own a 2006 280 sundancer went great first 5 weeks then blew a motor! repowered then blew a drive bought two new drives in the right ratio then had a bad transom assembly and now long...
  5. J

    Needed alpha one gen two transom assembly

    Any help would be Apreciated looking for a alpha one gen two transom assembly for an 06 280 dancer
  6. J

    What can my alpha one gen two handle?

    Hi guys just re powered my 06 280 dancer and now something in my drive is making noise. What is the max hp my alpha one gen two can handle and what gear ratio should they be? I put 350 mag mpi alpha motors in thay are 300 hp each and I don’t want to kill a new set of drives when I get them
  7. J

    Fresh water pump

    Hey all, have a 06 280 dancer my fresh water pump is not working I think the pressure switch was no good and I left pump on and it burnt out anyone know what pump I need for a direct replacement and where I could order one? Thanks!
  8. J

    Help!?

    Other day I was coming in and cruising 29 kt About 3900 rpm then both engines drop to 3000 rpm and I couldn’t get back on plane Changed fuel filters all other fluids seemed good then it happen again both check engine lit up on strbd gauge I slowed down and it went away any ideas??
  9. J

    Not planing and loses rpm

    Other day I was coming in and cruising 29 kt About 3900 rpm then both engines drop to 3000 rpm and I couldn’t get back on plane Changed fuel filters all other fluids seemed good then it happen again both check engine lit up on strbd gauge I slowed down and it went away any ideas??
  10. J

    Lost some power

    Hey all I was coming in yesterday and cruising at 3800 rpm doing about 29 knots when all of a sudden I lost speed and dropped down to 3000 rpm at wot could not get back on plane and oil pressure on was 50 psi on port and 25 on strbd (2006 280 Sundancer)
  11. J

    New cushions

    Hello all just purchased an 06 280 dancer would like to replace all interior cushions particularly aft cabin any know where to order new ones and I need sheets for v berth and aft cabin tried yacht bedding but they are super over priced and I’m not Sure what size to get. Thanks
  12. J

    Ac converter

    Hello everyone just bought a 06 280 Sundancer and in the panel there is a breaker for ac converter can someone tell me what it does and should it be on or off when connected to shore power and should it be on or off when not connected to shore power thanks!
Back
Top