Thanks for the help. Dometic finally returned my call and gave me the correct size (25 mfd 370vac) of the original capacitor. I installed it, along with the start assist and it still will not run. It no longer cycles. It trips the breaker. I suspect the compressor is bad.
I cannot find a tag on the compressor. I downloaded the install guide for the entire ac unit but I didn't see the model of the compressor. I'll look again but this is why I am asking someone else with the exact model to share the information with me. Thanks for the response.
I recently purchased a 1991 Sea Ray Sundancer 350. The bow air conditioner compressor attempts to start but will not run. It will cycle like this indefinitely until I kill the power.
It appears to me that the capacitor has been replaced at some point. I am questioning whether it is the same...
Great, thank you.
Also, if you have the original ladder and transom bench and ever decide to upgrade or swap them out. I would be interested in purchasing them.
Good luck with your boat! Take care
I have a 30 uf 370. That's why I think it's wrong. It tries to start, but after about three seconds it stops. Then about thirty seconds later it tries. again. Will cycle like this for a while but never starts. So the 30 micro farrods is got to be the start but the capacitor doesn't have run. At...
I am currently troubleshooting a Marine Air Systems A/C unit that someone has also attempted to repair.
The model is VRE12K-H it's a 12,000 btu unit.
I need to know what the size and specs were for the original capacitor. I think they swapped mine out at one point and it is not the correct size...
After thinking about it some more. The only other things I need are the hose and attachments for the central vacuum system and the original coffee maker. My boat is a 1991 sea Ray Sundancer 350. Not sure if the boat (s) you are pulling from will match but again, pictures are always helpful...
It's a ten inch pole, silver with groves that goes in between the table and the legs. It is used for when you convert the dinette into a bed to support the board that slides out over the opening. There should be two poles one is around 26 inches and the one I'm looking for is ten inches.
I'll...
Do you have the fold down ladder that mounts to the swim platform? Also looking for the small ten inch section of pole for the table in the cabin.
Thank you