I got around to adding an anchor washdown this past weekend. For anyone else that doesn't have this option from the factory you can tee into the fresh water supply behind the shower. From there it's a simple run straight forward to the anchor locker. Here's the parts I used.
20' of 15mm tubing...
Thanks for the suggestions! This is my first diesel boat. Just got it late last year. Working on getting a good baseline. Coolant has been flushed and raw water system has been serviced. Cleaning engines and bilge now. Fuel system is coming up next! I'll look into the options for replacing the...
I got the stainless exhaust elbow off yesterday to gain access to the water heater/battery area. This is my first time dealing with this but it looks like there is some damage to the fiberglass exhaust pipe. Does this look bad? What’s the fix here? Fiberglass repair? or cut off a few inches and...
I've purchased all the parts to install the tunnel trim tabs this spring. What is everyone using for sealant? I see Bennett recommends 5200 but I'm a little hesitant as these parts could need to be removed at some point in the future. Any issues using 4200 or something similar?
So unfortunately my 2000 410 da didn't come with a factory anchor wash down. I'd like to run a fresh water line from the pump under the floor by the stateroom entryway to the anchor locker. Has anyone added this before? Any suggestions on the best route to take for running the water line? Looks...
I'm considering adding a 32" tv in the salon. I'd like to put it on the fwd stb side of the salon. Has anyone removed this mirror? Tried gently prying with plastic tools but was a bit afraid of breaking it. I found this post where someone mounted on the wall of the fwd head but I'm concerned on...
Morning!
My sync gauge hasn't worked since I bought the boat. The needle stays almost in the middle and doesn't move at all when running the boat. From what I found on this site it seems the sync module behind the dash is a common culprit. I took the dash out and all connections were solid. No...
Hey Everyone,
Been stalking this thread for a good bit. Appreciate everyone who has been contributing! Wound up closing on a 2000 410 w/ 3116s this past Friday. Coming from a 290 previously, this is a lot of boat to get used to lol. Still figuring a few things out. Can anyone clue me in as to...