Search results

Is there an issue with leaving the camper enclosure on over winter? Boat is in slip all winter and covered but it's in the Midwest (Kansas). Was hoping I could be lazy and set it up and leave it rather than taking the other cover on and off each weekend. Didn't know if cold temps and wind would...

Posted this in another section but I added shelves to the front cabinet. Was getting very cluttered in there. Planning on doing the same to the mid cabin cabinet.

Did some organization over the weekend. The front cabinet had so much wasted potential. Planning on doing the same for the aft room storage

Thanks. I found you treasure trove of documents after posting my question. They have been immensely helpful, Thank You!!

I have a plug right there as well and earmarked it for the heater. Solid idea about moving the connection out of the engine bay

Thanks guys. This wouldn't be a permanent install. Just something to hang/place in the engine room to keep it warm over winter then remove in spring. Still think it needs all the fancy bells and whistles?

Will any space heater work or does it have to be something like the "XTreme heater" that GirlyGirl posted? I was thinking of getting a wifi controlled plug and space heater so that I can turn it on when not around dock. (Dock has wifi year round)

Float switch and pump work well. Water is coming back into the box and then reactivating switch and pump. Think I found a solution. Need a new valve in line. Product number is RULE-1240R

Looks like I need to replace the check valve on my shower sump pump. Was looking at this but there is not a whole lot of room in the sump box. What have you guys used? https://www.amazon.com/WHALE-WATER-SYSTEMS-Inline-Non-Return/dp/B00144AQG4

I used these for the little lights And these for the big lights Also needed these for the aft bedroom lights. Which also fit in the engine bay although they are not ignition protected. They do have a cover over the LEDs so I guess if the led pops it'll still be covered

Thank you all for the replies. Bought a new shift cable and going to install this week

Hey guys, Bought a new boat and everything worked for a couple trips out but now the starboard engine won't engage the outdrive. Boat is a 1997.5 sundancer with two 5.7 mercruiser and alpha 1 gen 2 outdrives. First, reverse stopped working then on another trip forward stopped. Now forward works...

This is a long shot but does someone on this chain or otherwise have the 4esz manual? Was unable to find it anywhere online

We can all relate https://streamable.com/q2yrme

That helps for sure. Thank you! Also looks like a pvc pipe could be cut to fit. Might need to taper the ends for a good friction fit

Haven't seen a pole that short yet. Might have gotten lost over the years or hiding in another compartment. Helps to know what to look for though! Thanks again

Ohhh, there are legs under the table. Couldn't figure out how the table was supposed to rest a foot off the ground. Makes sense now. Thanks!

Just bought a 1997.5 sea ray 290 and it came with these two cushions. I can't, for the life of me, figure out how they get positioned. Looks like they would go on the deck. My deck has a removable table with seats on either side. Anyone have these and can share?