Hello I am Installing Ray Marine Autopilot on My 360 sundancer the Problem is the Hydraulic pump has three ports and the Steering system only has two lines and it tells you to take the return line to the reservoir well I have no reservoir tank so i am not sure how to plumb the pump thank you in...
I have 2002 360 dancer I have had the same problem replaced the converter in both the freezer and fridge it is mounted behind the units on piece of plywood the relay in the converters go bad there is one for each unit remove the screws from the molding and units will come out one side of the...
Hello was wondering I if I can connect the Pathfinder smart heading System with the Gyro Plus 2 for the electronic Compass to the Classic C-80 Chart Plotter ,Radar thru the NMEA 183 or Sea Talk is it Compatible ? Thanks in Advance Tom
Hello was wondering I if I can connect the Pathfinder smart heading System with the Gyro Plus 2 for the electronic Compass to the Classic C-80 Chart Plotter ,Radar thru the NMEA 183 or Sea Talk is it Compatible ? Thanks in Advance Tom
Yep I Have That T Shirt Port side Is inside the Cabinet in the over the sink in the head and Starboard is in the cabinet in the aft behind the power panel hope this helps
I would check the power supplies behind the fridge and freezer there is A relay that flips one way or the other 120 or 12 volts I had to replace them both power supplies last year same kind of problems you can find them on line for about 120 bucks when I installed my new power...
Along the lines of the chop saw I used a four and A half inch grinder with one of those speed cut wheels (thin grinding wheels) works well but A little smokey
No i didn't shut down the other motor when i tried to restart the starboard thats good to know that both motors have to shut down before the smart craft system resets I am going to try the contact cleaner on the connectors and hopefully that will take care of the problem I hate these...
Hi does any one have any Ideals I was driving the boat in calm water and starboard motor quit while I was running 3800 rpm oil pressure normal temp normal
motor just quits the Mercruiser smart craft display says Crankshaft position fault 132 and camshaft position sensor fault I tried to...
On My 87 30 weekender I changed to dripless packings best thing that I did on the boat
made for A dry bilge realy not to hard to install and around 300 dollars A shaft,if you just want to repack the stuffing box there is some really good packing (GFO) http://www.gfopacking.com/
it was twenty...