just put in a new hardin sea pump in and now im getting 2.0 psi at idle and 18 at 3400 , prior i pull the hoses one by one on the raw water system to check for any blockage all seem clear , some one told me i could reset the code by key on an flip the safety switch on and off 5 times in 20...
hello all
i posted awhile back about check engine/sensor fault on my smart craft gauge , ONLY happens at 2000 rpms , replaced raw water pump with a hardin marine pump ( great choice)
im getting 3 psi at idle 18-22 at 4000 rmps .when alarm goes off the smart gauge reeads check engine/sensor...
the impella was intact when i replaced it , just put a brand new pump in and pressure switch 2.0 at idle and 5.1 at 3000 rpms and still getting alarm at exactly 2000 rpms
i have an 07 250 slx ( just purchased ) w/ 496mag bravo 3 , getting engine alarm at EXACTLY
2000 rpms , come up on smart gauge as check engine/sensor fault , mechanic said it was both knock sensors , i replaced both , changed plugs , wires , fuel filter and sediment filter and alarm keeps coming...
when i bought the boat the trim and tilt sensors were bad , i replaced both , used the smart gauge to set up , not sure if i did it correctly , my tilt sensor (port side is a 3 wire) , do u know how to set up correctly ? Also where is the shift position sensor located so i can check it
hello all ,
mechanic said code came up both knock sensor fault , changed both knock sensors , ignition wires (individual coils) , plugs , fuel filter and sediment filter , fuel is non ethinol , and still same alarm ....only happens at EXACTLY 2000 rpms then goes away... i am completely stumped...
changed wires , didnt work .... GETTING CODE FOR BOTH KNOCK SENSORS ........ PLEASE HELP..... alarm goes off at exactly 2000 rpms once above 2000 rpms alarm goes off .... smart gauge on dash says check engine/sensor fault
hello all,
I have a 07 250 slx with an 8.1 mag 200hrs , just bought the boat and it threw a engine alarm at exactly 2000 rpm , took it to mechanic and he said that the 2 knock sensor code , which he said was unusual he wants me to replace plugs fuel filter and sediment and wires <, There are...