Search results

When on battery and the fridge is not cooling, see if it is cycling - the compressor starts then stops right away, my 2006 44DA had the issue, the fix is to get a 12 v to 24v converter and up the voltage to the fridge, ( ensure the fridge is 12/24 VDC )

I replaced the water temperature sensor the gauge is now reading about 5 degree hire then the other engine, and does not climb above 174. So I believe I received the results I was looking for. I wish I used the IR gun before starting all of the repair work. I ran the boat @4400 -4700 rpm’s for...

There are three amps in some 340's the cabin amp is located behind the electrical panel. the other are under the cabin bench seat one is 1000 watt while the other is just for the sub woofer; but also large in size - I have replace all of mine except the sun woofer amp

Re: Official 2003.5-2008 340 Sundacer Thread Yes the filler cushion used the table. Slide the table into the groves in the rear horse shoe seating area. Then snap the cushion to the table and the seating area. need help - look for the snap on the seating area new the removable step cushion. As...

Gas Engine running hot !! I have a 2006 Searay 340DA with MerCruiser 496 engine connected to Bravo III I/O. My port engine is running about 5 to 10 degrees hotter that the starboard side. At idle the port is ~170 degrees while the other is ~165. When cursing the water at 4000 RPM the...

The installation instruction states the transducer must be mount over solid fiberglass, (not cored) so I’m trying to pole others that might have installed a large transducer, and find where they had the best success. The M260 mounting box can be modified to compensate for different angles, so...

Hello, I recently brought a Raymarine DSM 300 and The M260 high-performance in-hull 1 kW (Transducer). These will be connected to a Raymarine E80 chart plotter. I am looking to the best place to mount the M260 in the bilge. My 2006 340DA is equipped with 8.1 I/O’s. This was an...

I have 06 ‘ 340 DA I need some ideas to route wires from the cabin electrical panel to the engine compartment. I’m putting an inverter in to use the 23” TV off the batteries, instead of 120v. While traveling, my guest will be able to view the chart plotter screen on the TV. I have routed my...

I'll take it a part this weekend - and check, however now I'm wondering what would the control unit screw to, or how to fasten it inside. Thanks for all of the comments – and suggestions

I’m looking for a little help determining where to mount a Ray Marine Sirius SR100 control unit on a 2006 340DA. According to the manual ( ya I read it) it’s not recommend to mount the device in the engine compartments, and it’s not ignition proof. I looked at the helm and there not enough...

I wish the mattress would fit a 2006 340DA, I would like to know where you had the mattress made – it’s looks pretty good!!