Search results

It was very easy, just 5 Allen screws holding the sensor to the tank. My old sensor had two screw poles for the two wires. This one I just spliced the two wire together. One is for the gauge the other is the ground. As far as recalibrating I have not yet and it seems to be registering correctly...

Yes the starboard side is super easy and accessible, 5 Allen screws and it pulls out. The port side same but tighter. You can still pull out but can’t put in. I found there is an access hole if you open the port panel where you battery switches and breakers are at. Remove the four screws holding...

Just swapped out new fuel senders in the gas tanks of the 05 300 dancer. I finally got sick of them being way off and the smartcraft alarming when there was still 25 gallons in the tank. Not that hard of a job and now they should be way more accurate with the new style. Used KUS USA fuel...

Stoked, finally got all new canvass and glass. Upgraded to polycarbonate for all five panels in front of the arch and strata-glass for rear of the arch. Looks fresh once again.

The waste tank level indicator is located on your breaker panel. And to aloe the blower fans to work in the bath or kitchenette you need to flip the power vent button on in your breaker panel. Then those switches will work.

Aqua traction. 4-5 weeks from start to finish.

Lol the wife

They came out and digitally measured the inside for a custom fit.

Really enjoying the new to us 300 Dancer. The last couple months I’ve took getting to know the boat and it’s quirks. Did a lot of cleaning and installed new flooring, boat name letters, batteries, and smart tv, fixed small things here and there. I thought people would like to see the way I got...

Just a final update. Since everything else was working. I bit the bullet and bought a new control panel. That was the issue. All works just fine now as it should. Was happy to have air over the holiday weekend.

Okay finally was able to make it back to the boat today. I confirmed the compressor works along with the fan in heat mode. The compressor will kick on, water is squirting out the port side of the boat as it should. Once again try to set the temp to a lowered temperature and nothing happens. Hit...

Thanks I’ll give that a try.

Just one

No I’ll have to check the basket the next time I’m out. Yeah I don’t think the compressor is coming on. Just the fan motor. I can feel it suck the air through the filter etc. I’m guessing the basket will be down in the bilge by the raw water pump and seacock.

Yes the display lights up and displays the temperature. It will show the inside and outside temps. It allows me to change and set temps. It allows me to slow the fan or increase to Max. I can push the heat button and it will illuminate. Nothing happens when I hit the cool button. I tried to...

Good evening all. Have a new to me 2005 300 Dancer. Took possession of it a little while back. While I was out this weekend I tried to get the air conditioning going with no luck. When I turn in the ac breaker on the panel it sends power to the unit and the thermostat. The fan will blow but only...

If you don’t mind I have the exact same issue. I’d like to remove the steps then take to a weld shop. We’re you able to get the top unattached?

Hello! This is a long shot but I’m in the process of purchasing a 2005 300 sundancer. During the survey they found the welds on the bottom step to be cracked on both sides. Sounds like same issue as you had years ago. Did you ever find out how to remove the steps from the top? I need to get an...

Yes the step is starting to show integrity issues compared to its counterparts. Definitely a lot more movement/give than the other two which are not cracked. Obviously it’s no big deal to pop out the few screws on the bottom bracket however it looks more involved removing the top as I’m not...