Search results

My 280 Sundancer is currently on a 10,000 lb. lift in Cape Coral, FL. Is there a place in SW Florida (Ft. Myers area) to either rent a trailer when needed to get my boat on solid ground so I can do the periodic maintenance ... or to swap with someone that normally keeps their boat of that size...

Thanks - I've looked into that a bit. What I've learned so far is that the Alpha 1 series outdrives that we have are not compatible with these type of quick connect flush systems, because the pump system impellers are in the outdrives themselves. Which means I've got to flush the motors from...

Okay - why not?

As far as I know it has (I'm not the original owner). It's been stored out of the water on a lift - but operated in salt water for at least the past 10 years.

Does anyone have experience with converting their 4.3 liter Mercruiser engines to a 'closed cooling system' (like a kit from Performance Product Technologies)? The 280 Sundancer we purchased a few months ago has two of these engines, and I'm concerned about their long-term viability using salt...

We're in Cape Coral. We moved down full time about 10-years ago, but are just getting going with the boating. I'd love to hear any suggestions on good places to stop ... and hopefully over the next year or so, we'd like to start doing some weekend long trips. Any suggestions would be appreciated.

Welcome to the club! Are you a saltwater boater or fresh water? (I'm in SWFL and learning a lot about saltwater boating & the effects of corrosion) There are certainly a number of things on our list that simply fell into the category of keeping up a 20+ year old boat, however I'm learning that...

We had SeaDek installed about 18 months ago and a portion of the swim platform is starting to come loose at one of the edges. What adhesive should or shouldn't be used to stick it back down? Thanks!

Thank you Woody - I would have never thought of that. Thanks to everyone else for their advice as well. Keep it coming, I'm all ears.

We recently purchased a 280 Sundancer (2002) and have been correcting all of the punchlist items that were identified during the survey ... and a few that weren't. One issue we found, was that the drain hose on the step going down into the cabin (which goes out the starboard side hull) had...

Not sure if the dock was flooded during Ian (good chance it was). Our boat is not docked at a marina, it's occurring while on the lift at a private residence we rent the slip from.

I have a 280 Sundancer (2002), and occasionally when I'm plugged in to shore power the Red Light designated as Reversed Polarity comes on instead of the Green Light designated as Power. The AC Volt Meter barely registers anything either. It doesn't happen most of the time, but it has happened...

I've decided to go with an inflatable dinghy to be able to put muffs on the Alpha 1 drives. How long should I be flushing fresh water through each one? Also - I'd appreciate if someone could please walk me through the sequence step-by-step for flushing the motors, since this is our first...

We very recently bought a 280 Sundancer (2002) with twin 4.3 liter Mercruiser motors and Alpha One outdrives. We're docking it at a private residence on a 10,000 lb lift. My question is what is the best way to flush the motors? From what I have read, there are no flush kits available for...

Thank you! I appreciate it.

Thank you for the additional feedback ... it's helpful and I really appreciate it. Also, thank for the comment on our vintage 280 Sundancer. Over time I've developed an affinity for well-designed and well-proven older things (cars & now boats). We really like the layout & the feature package...

The picture shows the slip we are keeping the boat in ... so I'll be pulling in bow first at an angle to the canal (which is fairly wide) & backing out the same way - at least when we're at our dock. I've already seen that it can be a bit of the wild west at the other places we'll be docking...

It looks like we'll also be replacing our Lofrans Marlin Windlass Motor, and are wondering if there is a good alternative motor to replace it with. One that doesn't involve too much modification to fit the existing holes in the boat, and the controls. We have a 280 Sundancer (2002). Thanks...

Any suggestions on a replacement horn for our 280 Sundancer (2002)? Ours is functioning, but I can barely hear it at the helm.

After years of riding around on several of our friends boats, we just purchased the first one of our own ... a 280 Sundancer (2002). I'm currently addressing the items listed on the pre-purchase survey report to make sure she's ready to go. Also, having a couple of training sessions on...