I need to change the steering cable on my 2000 260da and unfortunately the p/n is not stamped on the cable. It’s just stamped made by teleflex. Does anyone know the correct length or p/n for this cable.
Thanks
Brian
I find water in the bilge after out running. If I'm out for 4 hours I get about a half a gal.. No leak with engine running at dock or boat sitting for a week. I am thinking it could be the transon seal? Any ideas
Thanks
Bmatt
Found saltwater seeping into the starboard vbearth under cushion.
the grey paint chipped off and now there is a seep into the area.
the boat has been sitting at the dock for 2 weeks and there was about 3 oz of salt water in the area. Any Ideas, hope it's not seeping throughout the hull. Pulled...
On my 260 da there is only one bilge pump. Has anyone added a second pump to there boat?. If so did you and a second thru hull drain line?. Surprised there is not a second pump.
The Amberjack's lost the battle with Sandy. Now on the lookout for another classic Sea Ray in the NJ area. If anyone knows of a good one please let me know.
Thanks
B.Matt
I have to replace the aft bilge pump on my 89 amberjack. There is no way I can reach the pump (the pump are on the bottom of the bilge between the engines), any suggestions on how to replace it.?
Thanks
B.Matt
The old boat needs some wood panels replaced in the cockpit area. Dose anyone know what they covered the plywood with.? It kind of looks like formica.
Thanks
I have to pull both engines on my 89 amberjack. The Marina will hoist them out and put them on a trailer. Does anyone have ideas about a cradle for the engines while transporting them?.
Thanks
B.Matt
Anyone with classics in the Jersey area want to have a meet some time in August.? My boat is in the Raritan area. I see some beautiful old Sea Ray's on the way to the bay must be allot more around.
I had to rebuild the seat pedastal on my 89 Amberjack. They are the back to back seat that fold down flat. There are three boards mounted to the floor but I don't see how the pedestal was ever secured. It doesn't look like the seat pedastal was screwed into the boards.
Thanks
B. Matt
On my 89 AJ with twin Merc 5.7l, the high water temp switch is not installed. Instead of having the high temp switch the hot water outlet is installed. Has anyone had this problem?. There is no alarm for that engine.
When checking alignment for the drive how do you know if the tool went in far enough. I greased the tool and it feels like its bottoming out and it also goes into both drives the same amount, but both engines where pulled before I purchased the boat and i'm not sure it was aligned right? Is...
I have a 89 270 AJ with twin 5.7l. Any ideas how to reach the oil drain plugs? Also does anyone know the size of the transom plug? (previous owner decided to keep it )
Thanks
Do you spray anything on wires to prevent corrosion? Also I read on the internet that anti-seize is no good on a boat in salt water, they actually called it everseize. I always use anti-seize and have found it great.
Thanks