I have been troubleshooting a problem with the rear-facing half of the anchor light not working when the Nav Light switch is in the anchor position. I finally found that two wires on my Nav switch were swapped. I have no idea how long they have been that way, as I normally never use that position. But in looking for this, I went back to the wiring diagram I created a couple of years ago, and changed the representation of the Nav switch. I suspect the wiring has been wrong since I did the original wiring check, but the diagram I made showed it as it should be. :huh:
I posted these before and they ended up in the sport cruiser section, so I am repeating the one post with the links to the diagrams here so I can find them next time.
There are likely some errors remaining, and a bit I don't know yet. Especially wire colors are hard to read. The Jack/Plug numbers are mostly assigned by me, as I could not read most, if any, of them.
The diagrams are too large to post here, so I will make them links that you can access by the small images following.
Please let me know if you finds any errors in these, or if you have more information about this. You will need to go to full screen mode and zoom in to 100% to see these clearly.
I posted these before and they ended up in the sport cruiser section, so I am repeating the one post with the links to the diagrams here so I can find them next time.
There are likely some errors remaining, and a bit I don't know yet. Especially wire colors are hard to read. The Jack/Plug numbers are mostly assigned by me, as I could not read most, if any, of them.
The diagrams are too large to post here, so I will make them links that you can access by the small images following.
Please let me know if you finds any errors in these, or if you have more information about this. You will need to go to full screen mode and zoom in to 100% to see these clearly.
