Russ Calasant
Active Member
I have an M1, one 12v receiver and three 110v, I used a splitter, destacker and a multi switch. The 12v receiver is in the cockpit where the signal from the sat is split and run back up the arch with RG6 where I cut the Glomex coax and connected my RG6. At the other end of that factory coax run is a Glomex control box and splitter that has OEM cable runs to the three tvs down below. I mounted the destacker and multi switch here and connected to the factory coax runs, to each of the tvs, to the multiswitch. I then went to the salon tv, removed it and wired in the 110v receiver and mounted a flat screen. It works great. So now the cockpit and main salon TVs are up and running. I move to the forward berth and wire in the second 110 receiver and it's searching for sat signal, box is good, went through it with tech support and have determined that it's not getting a signal. Now what? I don't want to have to run new coax. I am using OEM coax runs and no issue. I have also used SR OEM coax runs in my 370 without issue with an M3, it was a bit different because I have all 12v receivers in that boat so splitters no destacker or multiswitch that I recall. Anyone have any ideas? Any experience with sat and using factory coax?