After I get my SR200 Sport on the trailer and ready to head home, should I do anything to help support the stern drive in the up position? Sure seems like some type of strap would be appropriate between the prop and the ski tow eye, but I haven't seen any reference to doing such a thing.
Prop the Prop?
- Thread starter LJ2b2c
- Start date
ChuckW
Active Member
- Mar 6, 2009
- 1,487
- Boat Info
- 2007 RoadKing Tri-Axle Trailer towed by a 2013 Yukon XL K2500
- Engines
- 496 MAG Bravo III
I use trailering clips. https://plus22.safe-order.net/mercstuff/trailerclips.htm At WM, too.
Just put drive full up, cut to length of piston shaft, clip on, then drop drive a touch to take pressure off hydraulics.
Just put drive full up, cut to length of piston shaft, clip on, then drop drive a touch to take pressure off hydraulics.
Ditto what Chuck said. You should be able to get these at any marine store.
Just don't "trim down" too hard - you'll split them right in half. Trim down just enough to snug the clip to the point where you can't move it by hand.
Just don't "trim down" too hard - you'll split them right in half. Trim down just enough to snug the clip to the point where you can't move it by hand.