Recent content by Chaz_360

  1. C

    Calling all 360 DA owners

    I have not done this myself on my boat, but I helped a friend do this on his newer sea ray 370 Sundancer & took notes for when I do this on my 2002 360 Sundancer (I have ZF Hurth model HSW630V1 transmissions). It is a pretty straightforward / simple DIY project. I believe you need 4-5 quarts...
  2. C

    Calling all 360 DA owners

    I replaced the vent window gasket on my 2002 360 in August 2023. I did a short write up on the "SeaRay 360 Sundancer Owners" Facebook group page. Here are the pertinent details: You need about 6' total of WS80 windshield gasket....I ordered 8' so that I would have 2' extra just in case. This...
  3. C

    Calling all 360 DA owners

    Clear coat had seriously deteriorated on the cover for the center vent window actuator. There is an older post in the Sea Ray 380 Sundancer Owners group on Facebook where a guy had spray painted his with good results so I decided to do the same thing. My 360 Sundancer is a 2002. Here is...
  4. C

    Calling all 360 DA owners

    Here is a picture of the two cushions on my 2002 360 Sundancer. There are 4 straps on each cushion, each strap has one snap on it. The snaps attach to the bottom of the tables.
  5. C

    Calling all 360 DA owners

    Curiosity got the best of me about a month ago and I opened that panel to see what was there. I went in there looking to see where the water that enters that small drain hole gets routed to, and best I could tell it just runs along the floor to the starboard side. Here are two pictures - one...
  6. C

    Calling all 360 DA owners

    Responding to post # 1803 - I have a 2002 Sundancer 360. The existing power supply was an MPS-35 and it was mounted to the bulkhead on the port side - it was NOT attached to the freezer as shown in your pictures, so perhaps the freezer design was changed at some point. I replaced it in May 2022...
  7. C

    EVA foam decking

    Update - the Purple Power cleaner / degreaser definitely worked best out of anything I tried yet (I did not attempt to use a pressure washer). I was able to get probably 98%+ of that backing off with the Purple Power and a lot more elbow grease. I wore rubber gloves the whole time which was...
  8. C

    EVA foam decking

    I find myself in the same situation as many before me, removed the original cockpit carpet on my 2002 Sea Ray 360 Sundancer and the black 'rubber' backing was stuck / adhered to the non skid floor. After 2.5 hours of cleaning and srubbing I have most of it gone, but there are some stubborn...
  9. C

    Chicago - Canvas and Electronics Recommendations

    Talked to the guys on the dock, they all spoke very highly of Arts Wired Electronics....here is the email address: art@artswired.com I saw on his Facebook page he has a short video of the install he was doing on the Cantius...looks like he does a lot of marine installations.
  10. C

    Chicago - Canvas and Electronics Recommendations

    Welcome to 31st st harbor! I am in a 2002 360 Sundancer, just a couple slips down from you. Vince at Chicago Marine Canvas does quality work. As far as the stereo, our dock neighbor in the Cantius just had a guy doing work on his stereo last week, i'll get the contact info next time I see...
  11. C

    Used U-Line Icemaker

    Hi sorry for the delayed response to all of this! I ended up deciding to replace the existing unit with the NovaKool R1200 AC/DC, but that combo unit from U-Line looks like the best of both worlds. The ice maker is still available, if anyone is interested please let me know and ill try and...
  12. C

    Used U-Line Icemaker

    Selling my used U-Line icemaker, model # ULN-WH95TP-03. 115 Volt AC. This was recently removed from my 2002 Sea Ray 360 Sundancer (the boat is new to me this year, the icemaker appears to be original to the boat). I only used the icemaker a few times this summer, it worked great and is clean...
Back
Top