No, it is only around the ski/anchor storage area in front of the gas tsnk area.
Im also looking to repair the boat, not sell it.
Im looking for repair advice and not an 'armchair' lawyer response.
Having boat-sold or traded more tha 15 boats on Lake Michigan, I certsinly know disclosurer...
Hi All
Relocated to South Florida 18 months ago
Sadly had to sell (pending) my 350EB in Chicago
Have a need
I have an older Larson All American 17.5 ft
I need to replace the flooring as noticed some soft spots over the weekend
Looking for recommendations in Winter Haven , FL or South...
Looks like a great trip
Mahogany Rose was in Hammond Indiana a 2 seasons ago
Got to meet Dennis the owner, great guy
To a cruise up to Chicago one afternoon
Unbelievable boat and a great story behind it's build
The interior is nothing short of spectacular
The woodwork, all Mahogany with Teak...
I am looking for the Electric Panel Mounted Off-On-Intermittent Starter Switch
for my Quicksilver 5.0 Generator
Have finally traced down the bug and it is a bad switch
Based on a Sea Ray Manual the Part Number is 345595
It has 5 terminals on the backside
I have tried Flounder Pounder but...
Thanks
Boatingnut
The Rotella SAE 30W is all I have run in this boat for the past 10 seasons and have
done oil analysis through Blackstone and have seen no changes.
My concern was the label change to Diesel
I did see Wal Mart still has the old label Conventional Engine Oil
I'm stopping by...
OK
From what I have been told
The Shell Rep has told all of the Auto Parts Stores I have contacted
is that the only change is to the label and the pouring system to make it easier to pour
But I do see that the rating has been changed to API CJ-4
SJ and SN are no longer listed
Still concerned...
I have always used Rottella 30W Engine Oil in my 1992 350 EB with 445 330 HP engines
The label always read:
Rottella SAE 30W Engine Oil
The new Label reads:
Rottella SAE 30W Diesel Engine Oil
The old part number is the same and...
My Bad
Prince William Marina
Usually once a year they post a list of overstock parts
http://www.pwmarina.com/
Also try Flounder Pounder
I have gotten stuff from them
Dan
I got my oval base through Prince Edward Marine here on this site
I then went to Garlick and purchased the post and the receiver for
the bottom of the table and made my own table
White Laminate top with half round Oak edges
I used to break it down and put it inside during the week but had...
I'll be pulling Oct 14
Had a great year
On the boat every weekend Fri-Sun
Made more out of harbor overnight trips this year that the past 2 years combined
Helped to see $2.99 a gallon gas for a few weekends!!
Trying to sneak in one more overnighter to
Michigan City or Portage before the end