Recent content by Larry Gee

UPDATE - Installed both NEW SC 1000 factory Tachs. It was plug and play except for the Port gauge showing error Fault Pitot - I believe the Pitot is assigned to the Starboard engine so I will have to go into the calibration 2 setting of the Port gauge and disable. Will be sending the speedometer...

Thanks - just wondering if the software versions are different between the old and the new which I believe they are, and will this be an issue installing new factory SC1000 Tachs.

Has anyone replaced their existing SC1000 Tachs on their 340, specifically SC1000, with the exact same NEW ONES? Wondering if the new ones will both need to be re-calibrated or will the existing engine info stay populated? ...fuel tank capacities, etc...like plug and play...TIA

Another angle..

Installed - had to cut 1/16 off the cabinet

Pic of Isotherm 130 right before install

Isotherm Cruise 130

On Amazon it is from the Heyalan Store - Cold Water Only Kitchen Brushed Nickel Single Handle 1 hole 360 Degree Swivel Spout Deck Mount High Arc SUS304 - there are 2 sizes - I went 8.3 inch but 11.8 inch is also available - @ $22.00 - Let me know if you need more info!

I have the same style faucet off Amazon that I installed right before putting in new fridge...Both easy installs!

April / May 2023 Updates - - Garmin AIS 800 - Reworked the NEMA 2000 backbone w/2 4 outlet backbone - New outside fridge replacement - Norcold 740SS

Received the Acuators ( Bennett part # A1101A ) and Trim Tab Hydraulic Hardware Pack ( Bennett # H1170A ) - might as well add new fittings, etc. but haven't installed yet as it has been way too cold for my diver /mechanic. Will update once installed. Also replacing the Kohler model 5E...

That does help a lot! The pictures really help and thanks for taking the time to reply. I keep the boat in the water and my diver at the marina who says he can do it in the water at my slip. I will call Bennett tomorrow to get the actuators and parts. I will post how it goes when done.

Anyone replace their trim tab actuator? My 2006 port is leaking on the outside and suspect it is a seal. I want to just replace the actuator and have 2 questions - 1)what is the size and part number ? and 2) has anyone successfully done this while in the water?

Perfect - thanks Siboatguy - if I don’t see any flow tomorrow I will hook up my shop vac to clear the line.

Yep - did that - even added a bit of soap to make it easier to soot outside but nada. Looking to see if it is on the port or starboard or in the engine room bilge. The manual is no help. A mystery so far unless someone knows for sure…thx