Recent content by Mark.60

Whenever I have to work on the head systems I flush a gallon of Simple Green. It smells much better when you remove hoses, or replace duck bills

You also have to be a certified diver to fill any tank in a dive shop. A 21 cubic foot tank is about 4 inches in diameter and 18 inches tall

I have been diving for years. I keep a 21 cubic foot tank with regulator on board. Be careful doesn’t take much to get hurt underwater. Those small devices don’t have a pressure gauge so when you run out of air your in trouble.

Thanks, just placed my order on Amazon

Does anyone know the formula to make Noflex digester. I know it’s been posted just can’t find it.

Thanks, after looking back I remember it now. I am in the process of gluing up 3/4 inch teak and maple into two sheets. Cut to shape and install as one piece.

Has anyone removed the hardwood floors in the galley and dinette? It’s time for a facelift and wondering if it’s glued down or screwed down.

I installed the Nova Kool freezer on bottom. The unit has two compressors seems to be very efficient. It’s much bigger than the old Norcold. No pictures as the boat is hibernating until spring

maybe if you attach that fin to your mailbox it will keep the trucks away. sorry couldn’t resist

I removed the stbd pump without removing the exhaust tube. I did remove the tube to replace the water heater. I plugged the exhaust with a football from Walmart as water was coming in. It wasn’t pouring in but enough to make me nervous.

thanks for the quick response

I believe I have a bad fuel injector on port motor. The cost for a tech to plug in a laptop is far more expensive than send all six injectors out to be cleaned and tested.Then rebuild or replace bad one. My question is on the QSC motors does the new injector need to be programed ?

When you changed the cup did it affect your wide open RPM or are you still at the 2680 range

I used white top coat and had it color marched at Ace hardware. I took a color sample from paint chip. Mixed it with west systems resin and the slow hardener. I cant read the formula on top of the can as it’s covered with paint. It’s been a few seasons and still looks great

I was but aboard my friends new 64 Viking.