TotallyGross's latest activity
-
TotallyGross replied to the thread 40 sedan bridge forum.Coop, You don't want to replace your entire cord or when you travel it will be a headache. I have the smart plugs on my boat side and I... -
I don’t know enough about Smartplug to help you. I can tell you that if something on my boat lasts 20 years, I’m buying it again when...
-
TotallyGross reacted to scooper321's post in the thread Official Cummins 6cta 450C thread with
Like.
After 23 years and 1100 hours, yes, you do need to clean your after coolers and heat exchangers. You Sundancer guys with the V drives... -
I have the 8BTDA gen too. My raw water pump is on the end of the generator on the port side. I do need to remove the belt guard, but...
-
TotallyGross reacted to scooper321's post in the thread Official Cummins 6cta 450C thread with Like.
Could be. But that's way down the list of things to look at. I like Bill's suggestion or spinning the turbo by hand. I know I'm not...
-
TotallyGross replied to the thread 40 sedan bridge forum.Did you look behind the TV in the master stateroom? I seem to remember it passing through there when I was removing the TV. I finished...
-
Thanks again, after taking the belt cover off, it was pretty easy. Glad because this one is shot!
-
TotallyGross replied to the thread 40 sedan bridge forum.I have an 02 diesel westerbeke. Does your impeller face the port side? I don't have a difficult time getting mine out. I loosen the...
-
TotallyGross replied to the thread 40 sedan bridge forum.I too routed my galley sink overboard like Drafter. I feel it keeps so much growth and nasty stuff out of the shower sump. We cook...
-
I I bought these. Got mine from Hodges Marine, but this part number. I didn’t see a reason to unbed the factory switch and tossed...
-
TotallyGross replied to the thread 40 sedan bridge forum.Which covers did you order for the windlass deck controls? I ordered the wrong size and had to send them back. I need to replace...
-
btw 2nd inline muffler I assume is fine for Gas but I read somewhere it's not recommended by Westerbeke for Diesel because of back pressure.
-
Looks like it might be good for parts