Search results

  1. H

    Bravo 3 III Mercury 22P prop set

    Set of Bravo 3 22P props Good condition, no vibrations, changed to a lower pitched set due to engine swap. 48-823664 and 48-823663 $450 for the set local pickup on Long Island or $450 plus shipping. call or text 516-697-8032 Happy boating!
  2. H

    Cheap inexpensive LED upgrade

    (redundant title for easy searching) I decided to do as much LED swapping as I could on my 270 - and started the typical research online. There were a number of threads that were very helpful here, but most pointed to LED sources that frankly seemed incredibly overpriced for what they were...
  3. H

    missing trim endcap, large holes

    Noticed the trim endcap on the aft port side is missing leaving two nice sized holes through the side of the boat. 1) assuming the boat was run in this condition likely they were submerged at least momentarily by seawater - what potential damage could I be looking at if any? 2) repair...
  4. H

    Analog Tach troubleshooting

    Looking for tips on how to troubleshoot my analog tach. Boat is a 99 270 - guages are original. Boat was re-powered in 05 with a 6.2 mpi that has smartcraft. I have a northstar GPS hooked up that gets smartcraft engine info so I have an accurate smartcraft tach reading from there. But the...
  5. H

    Possible starter damage?

    OK - here's what happened. My batteries were 3 years old and I was trying to stretch the rest of this season out of them. No real problems were noted prior to this incident other than they weren't holding a charge as long, especially one of them .. So Labor day weekend the marina I usually...
  6. H

    How to remove front berth side bolster panel??

    Anyone know how to remove the middle vinyl panel on the side of the vberth on a 99 270 sundancer? (there are three distinct padded sections going up the side of the hull, the top and bottom are just flat and the middle section is a padded B shaped bolstery looking section.) I have to access...
  7. H

    Bent/loose bowrail base .. potential damage?

    Ok so going up the port side of my 270 the bowrail bends in slightly at one spot - it likely was on the wrong end of a battle with a pole or something - It has been like this for several years. When polishing the stainless yesterday I noticed the circular base for the stanchion nearest where...
  8. H

    Under $300 portable AC install

    Starting a thread here for my project this weekend, which will be the setup of a portable AC unit to cool my 270 on overnights. My plan: Setup the cabin to use a Koldfront PAC801W (purchased new online for ~$230 including shipping, I won't spam any site specifics) 8000 BTU portable AC unit...
  9. H

    6.2 MPI low WOT rpms

    So I have a 99 single engine setup 270 that was repowered in 2005 with a single 6.2 MPI. It sat unused for a while, I bought it, and I've run it for the past 3 seasons. other than some trouble with the coil wiring and the cool fuel system, its been pretty solid but I'm on a quest to get it...
  10. H

    2004 6.2 MPI Stalled / Won't Start - Need Mechanic Reccomendation

    Hey guys, hope someone can help. I need a recommendation for a good mobile Mercruser mechanic on long island who knows MPI engines. I've been battling random shutdowns on this engine on and off for two seasons now. Basically the boat runs perfectly fine then under load it just completely...
Back
Top