definitely a bravo one. A very uncommon set up. I believe the one I did find is the drive coupler on the inside by the transom underneath the steering cables, etc.
I believe that “zerk” is the proper term for the grease fitting…
OK could only find one of allegedly three grease points for 2010 MerCruiser 5.0 with a Bravo One. Does anyone know where the other two are or have a picture?
I change my fuel filters in the spring after I start the motor and let it warm up after it’s long winter nap… oil filter gets done with the fresh oil at the end of the season.
FYI, I did the fuel mix and drained the boock prior to using the pink/purple stuff. I also lucked out in that a friend...
Hello all!
When winterizing my boat this past weekend I had a very hard time with a fuel fitting (tank side) when I removed and reattached it at the tank (to connect to a pony tank with the winter mix) I think the 3/8 inch hose from my Cool Fuel module needs to be replaced. 2010 Mercruiser...
Hello all!
When winterizing my boat this past weekend I had a very hard time with a fuel fitting (tank side) when I removed and reattached it at the tank (to connect to a pony tank with the winter mix) I think the 3/8 inch hose from my Cool Fuel module needs to be replaced. 2010 Mercruiser...
So if I just open up where my fuel filter is by the cool fuel module I could just pour directly into there and just let it run when I flush the pink through the motor? Sounds too simple..
So if I just open up where my fuel filter is by the cool fuel module I could just pour directly into there and just let it run when I flush the pink through the motor? Sounds too simple..
I’m winterizing my engine this weekend and wanted to know if someone can tell me the proper mix for the fuel system for a MerCruiser EFI 8 cyl. inboard/outboard with a cool fuel module.
I know it’s a combination of gas in a small po y tank,, two cycle oil and stabilizer but want to reconfirm...
OK I think I have an electrical problem with my speedometer gauge. I turn the ignition on and the speedometer jumps up to about 65 and stays there till I turn it off.
Any ideas how to troubleshoot this or where to look?
Anyone know the dimensions (measurements, diameter, poundage) of this extinguisher?
How about where I can get a composite bracket replacement (not metal)?
Believe it or not I had to resort to walmart.com. The measurements do vary and all the ones on Amazon were slightly too big than existing opening — which I don’t want to modify.