OK could only find one of allegedly three grease points for 2010 MerCruiser 5.0 with a Bravo One. Does anyone know where the other two are or have a picture?
Hello all!
When winterizing my boat this past weekend I had a very hard time with a fuel fitting (tank side) when I removed and reattached it at the tank (to connect to a pony tank with the winter mix) I think the 3/8 inch hose from my Cool Fuel module needs to be replaced. 2010 Mercruiser...
Hello all!
When winterizing my boat this past weekend I had a very hard time with a fuel fitting (tank side) when I removed and reattached it at the tank (to connect to a pony tank with the winter mix) I think the 3/8 inch hose from my Cool Fuel module needs to be replaced. 2010 Mercruiser...
I’m winterizing my engine this weekend and wanted to know if someone can tell me the proper mix for the fuel system for a MerCruiser EFI 8 cyl. inboard/outboard with a cool fuel module.
I know it’s a combination of gas in a small po y tank,, two cycle oil and stabilizer but want to reconfirm...
OK I think I have an electrical problem with my speedometer gauge. I turn the ignition on and the speedometer jumps up to about 65 and stays there till I turn it off.
Any ideas how to troubleshoot this or where to look?
Anyone know the dimensions (measurements, diameter, poundage) of this extinguisher?
How about where I can get a composite bracket replacement (not metal)?
Anyone have any luck/experience in replacing the “stock” Sylvania microwave with one that fits into the existing opening/cabinet in their 240 Sundancer? It a Sylvania Model #sh11050 microwave oven (about .7 cubic feet).
The microwave oven died and I am looking for one that will fit in the...
Running power to new amplifier from the port batteries and I am wondering the best way to do this. I am thinking that somehow the panels on the interior port side of the rear berth come out. I am thinking that I could see the waterlines and run them past that. Does anyone know how to remove...
So, my windshield shattered a few weeks ago when I got hit with debris from a storm. I settled with the insurance for a new replacement but, as it is ridiculously expensive as the entire port frame needs to be removed and shipped up and back to Taylor Made for replacement, I am exploring options...
This weekend I had the unfortunate discovery that the port-side curved glass on my windshield shattered at the dock after some really wicked weather.
My winter marina will be reaching out to Talyor Made for replacement glass but I called them directly and they are unsure if they have any left...
Hi Guys,
My 2010 240 Sundancer's tabs are not moving (neither side). I am troubleshooting again tomorrow (prior to the 110+ real feel temps kicking in on Long Island - boat is in Great River, NY) again using YouTube info but would like to know if anyone has part numbers or location to get...
RESOLVED ON 5/30: Marina had reset the Smartcraft settings during Spring Prep when they cleared alarms for the water pressure sensor they replaced. In doing so, they knocked out the recognition of the transducer. They went down to the boat today and reset Smartcraft settings which then picked...
Good Day Everyone,
Marina says I need to replace the all the bellows on my Bravo1 as they are the originals and are starting to push the limit before dry rot kicks in. OK, so I agree with them as I am sure it should have been a tad sooner. They are the originals from when the boat first...
I need to remove the port side lounge seat/cushion (the bottom part).
For the life of me I can't figure it out how it is attached.
Has anyone ever done this before? Pictures?
I need to remove it so I can get it reupholstered.
All,
I need your opinions on an estimate that I got this morning to replace the risers and manifolds on my 2010 raw water cooled MerCruiser 5.0L. I know that this is a necessary (and perhaps slightly overdue) maintenance item, but the cost of the OEM parts made me choke on my coffee when I...
So, I am coming on the time in which I think I need to consider replacing my risers and manifolds. My problem is that no marina is thrilled on working on my engine!
I have a 2010 mercruiser (splashed in 2011) 260hp ect mpi that is raw water cooled (it does have a Volvo Neutra Salt system I...
Does anyone have a phone number that works for them? The old ones I have are out of service...
My wiper arm on my 2010 240 Sundancer is worn/stripped, and I need a part number and/or manufacturer name to try to track one down -- before I am forced to call a dealer for one (and thus pay top $)...
The head of my faucet flew off under pressure today and its guts were broken inside. Does anyone know the manufacturer and part number of the stock faucet and spray head from SeaRay for a 2010 240 SunDancer? If not, do you have SeaRay customer service number handy?
I am hoping its a major...
Looking for suggestions here.
My daughter, who is an outstanding high school senior with an awesome resume both academically and extracurricular/volunteering (i.e. Local FD, hospital, Rotary/RYLA/Interact, etc) has applied to UPenn, Yale and Barnard and is waiting to hear back. But, as I am...