My ray marine vhf has died and it appears to be too old to repair (12 yrs). I can buy the self contained unit for a third of the price of a new ray marine one. Just that I have to find a place to mount the new unit and then I have a dead speaker and handset from the old unit. Any ideas or...
I have twin Bravo 3's with 496's on a 390. I have low water flow coming into the water pump, maybe 30% of the other side. The entire transom and drive were new 4 years ago. I doubt, but maybe wrong, that it's the Bravo-itis. I can back flush the drive by forcing water back through the drive...
Generator has always run fine and has 300 hrs and is about 10 yrs old. Just lately it would start and then stop. Thought I had just run it out of gas. All the maintenance had just been performed but I went through the gas lines all the way to testing the fuel pump. I took the pump off to...
I've got a sundancer with mercruiser 496's, 2009 model year. Which by the way, I heard was the last year they were made. Something in the lower unit let go this weekend with 550 hrs on one engine. I'm trying to figure out the easiest and best way to get it repaired. Mercury only sells long...
Has anyone successfully repaired an acculift? I finally got one apart but now I'm searching for a source for the worm gears. Been through KHK and Boston gear with no luck.
2010 twin mercruisers 496's sterndrives with DTS/ Axius. I'm getting an alarm on vesselview "Sensor Power Supply voltage low". I've checked the 5 volts on the manifold, temperature and water pressure sensors and they are all at a solid 5 volts. Also, this alarm is both in the active alarms...
I'm having a problem with overheating and the engines going into "safe mode". It only happens over time when running pretty well full rpms. The temp gauges read 175 when it drops to guardian mode. I live 100 miles from any mercruiser dealer that can work on my boat. I replaced the water...
Have a 2010 Sundancer with Gen I Axius. I’ve just started getting a TVM maintenance alarm- non- critical. Does anyone have any experience with this? I can’t seem to find any information anywhere about this alarm or any troubleshooting.
Looking for any help trouble shooting the autopilot/skyhook on a 2010 390 DA. Worked when I purchased the boat this spring and after trucking the boat to the gulf coast we can't get it to work. Had a SR mechanic look at it several times with no luck. Any help would be appreciated.
Looking for a good, reliable mechanic on the gulf coast willing to travel to Biloxi Ms to work on a SR 390. Needs new outdrives and work on Autopilot and Skyhook. Looking for recommendations.