I have been thinking about completely redoing my dash. I was thinking about a 7 inch nav unit right in the center. Them getting new gauges and have one of them be a 4 in one for water temp, oil pressure, volts, and fuel. This should free up the space I need in the middle of the dash.
I had family in town and they wanted to go out on the boat. It had been a while since we had taken it out so I put some muffs on it and ran it at home for a bit. Everythiong was fine on the dash but the water pump seemed to be making noise. We took it out anyway and to no surprise we over...
I want to remove and paint the emblems on the side pocket panels of my 210 sun deck but I'm not sure how they are attached. I don't want to pry to hard on them and snap them. Has anyone removed the emblems before?
When I bought our 2000 210 the cooler was not there. Found the one that came with the boat and I kid you not the third time I used it the handle ripped off the side of it. I had another cooler on wheels that was slightly bigger and didn't fit in the rails so I moved the rails over to...
It looks like I need a new starter so I started searching the internet for one. It looks like I can get it cheaper from Amazon, but I feel bad not supporting marine suppliers. I feel like the $5-10 dollars more through a marine supplier just makes more sense in the long run. What are your...
Agreed, if I found that I would replace the coil, distributor cap, wires and plugs. That coil is a bitch to get out. Do yourself a favor and remove the seat base, the risers and manifolds. Once those are out of the way you can have the rest done in an hour or less. When you go to put the...
My bracket on my 2000 210 Sun Deck has become fatigued and bends when you close the hatch. Has anyone had to replace this and where did you get the part from? I have done a search for the part number and part name and not finding the Sea Ray part. 634550 BRACKET, SS GAS CYL 90DEG L-BRKT...
So after 3 months I finally got my boat back from having the lower shift cable, gimbal bearing, u-joints, coupler, bellow, and impeller replaced. I tried running it on muffs Saturday and it wouldn't start. I found the mechanic knocked the coil wire off. Once I got it back on I ran it for a...
I was thinking of trying this one. https://www.amazon.com/dp/B000MTCRJG/?coliid=I6UXD7TWKWGLF&colid=2AYBL1DGLVWQS&psc=0&ref_=lv_ov_lig_dp_it Have you tried one like this yet?
I am going to rebuild my trim cylinders and the bag of parts shows one more o-ring than what Mercury calls for. Per their parts listing there should be 6 o-rings but there is 7 in the bag. Thoughts?
This weekend I went to lower the drive unit and it didn't go down. I tried pulling on it as someone pressed the button and nothing. I figured the cylinders were frozen. I took them apart so I could rebuild them and found water had gotten in and now the fluid has that milky look to it. I was...