Ok I have an update to the problem. They found fuel filters near the tanks, replaced them, also cleaned the carb and replaced the filter there! Bingo runs like a charm….. blast along at 4,000 rpm!
Thank you for all your inputs, yes I took the other fittings apart to check. I didn’t find a steel washer in the assembly, so my be I will head to Home Depot this week and look at replacing the fittings.
Cheers Rob
Hi yes I get really hot water, I just reassembled the fittings. Tomorrow I will check the pressure relief valve. When I open the tap for the hot water there is a build up of air pressure before the water flows, only when I’ve had the heater on.
Hi Guys,
I switched the water heater on and after 20 minutes the plastic hose came off a compression fitting under the steps next to the pump. I took it all apart cleaned and reassembled and it held the water pressure. So a day later I switch the heater on again, the water starts to heat up but...
Hi guys,
I am in desperate need of a replacement Thunderbolt IV breaker less electronic timing ignition. Mercruiser v8 7.4 454, 1986 engines.
I had a tune up and my mechanic is having a hard time sourcing the part.
Boat runs great except getting on a plane the port engine starts to miss. Summer...
Hi Guys,
Remember I had the port engine start missing trying to get on a plane around 3000 Rpm. Well so far the mechanic has replaced the rotor cap assembly, pints and plugs, and I still have the same problem. The boat runs fantastic at cruising speeds, sounds great, but missing getting on a...
Hi all,
Filled up with gas, pump out, took her out on the lake. Engines running great, cruising at 1500 to 1800 rpm, when jacking her up to get on plane port engine starts to miss. Bring the rpms back down runs great?
Going to call the marina tomorrow to check it out, I’m leaning towards...