Search results

Hi Guys, I switched the water heater on and after 20 minutes the plastic hose came off a compression fitting under the steps next to the pump. I took it all apart cleaned and reassembled and it held the water pressure. So a day later I switch the heater on again, the water starts to heat up but...

Hi guys, I am in desperate need of a replacement Thunderbolt IV breaker less electronic timing ignition. Mercruiser v8 7.4 454, 1986 engines. I had a tune up and my mechanic is having a hard time sourcing the part. Boat runs great except getting on a plane the port engine starts to miss. Summer...

Hi Guys, Remember I had the port engine start missing trying to get on a plane around 3000 Rpm. Well so far the mechanic has replaced the rotor cap assembly, pints and plugs, and I still have the same problem. The boat runs fantastic at cruising speeds, sounds great, but missing getting on a...

Hi all, Filled up with gas, pump out, took her out on the lake. Engines running great, cruising at 1500 to 1800 rpm, when jacking her up to get on plane port engine starts to miss. Bring the rpms back down runs great? Going to call the marina tomorrow to check it out, I’m leaning towards...

Why didn’t I get the shrink wrap again. I thought I would cover the boat myself in the fall, and save some money. It took two days of cleaning the mess the mice left! Guess what, shrink wrap next fall. Cheers Rob

Hi Fellas, I purchased a Boss blue tooth marine stereo system 4 ohm 200 w with two marine speakers 2 way. I need two more speaker for down in the salon, as I tossed the old clarion out. Am I limited to buying 2 way or can I use 3 way speakers as long as I stay with 4 ohms? Appreciate any input...

Hi gents, Our glorious leader has put us (Ontario) in lockdown until 20th May.... Including marinas! So I can’t get to the boat before it’s launched to buff the topsides. The “Ford” does not listen to the scientific community, I have worked hard all winter and so looking forward to getting on...

Hi Guys, I replaced my impellers 3 years ago, just wondering if I should change them out again. Fresh water Georgian Bay. Cheers Rob

Hello boaters, Looking for advice on creating a wider swim platform on my old girl. I have upgraded everything else this the last thing that needs to be completed lol. Cheers Rob

Hi Guys, Just changed the oil and filter before winter haul out. My oil pressure at 600 rpms on the port engine reads 30psi and starboard engine reads 40. Running at 3,000 rpm I get 50 psi on the port and 65 psi on the starboard engine. Should I be concerned or assume it’s the sender units and...

Hi Guys, Returning from our favourite swimming hole, about a 1 hour ride back to our marine at 22 knots, my port engine started missing while on a plane. I played around With the throttle but couldn’t get the rpms above 3000. Seamed like it was fuel starvation Or electrical, kept on a plane...

Hi Guys. I think my shaft packing has reached the end of its life Span. I cannot tighten the Bronze packing Nut Enough to prevent a steady drip of water. My question is from what I have read from previous posts is it safe to repack while In the water and should just install one ring for now...

Hi guys, The drive shafts stuffing boxes were repacked with 5/16” Teflon packing 2 years ago, when should I look at replacing the packing? I adjust/tighten the nut every-time I return from a cruise. But it’s getting harder to adjust, could I install a couple more packing rings while the boat is...

Hi guys, Looks like I will be needing new starter battery. Any recommendations? Cheers Rob

Hi Guys, Just had the boat launched, summarized and ready to go. The mechanic noted on my bill that my port side rudder post has a slight leak, and to keep an eye on it. What exactly does that mean, new seals or tighten something........or haul out? No sure can someone enlighten me please...

Hi guys, My two Shakespeare 8ft antennas are in need of replacement, breaking off near the thread.......sunlight and age.....sounds like me lol Anyway instead of buying the whole replacement and cables, could I not just purchase new antennas and just swap them out keeping my original cable hook...

Hi Guys, I had my cushions made by local upholsterer, I made the 1” thick Ash table to match. Turned out great! Cheers Rob

Hi Guys, Stained the galley table Rubio walnut, turned out really nice! Cheers Rob

Hi Guys, It has been a labour of love for my 86 34’ EC. I have replaced the canvas including adding cockpit enclosure, removed the pink shag carpet and replaced with vinyl waterproof flooring. Built dinghy davits. Built new companionway stairs, adding an extra stair for my old knees, repainted...

Hi Guys, Looking to purchase a pedestal barbecue mounted on the swim platform. Any recommendations out there. Cheers Rob