Search results

I have a sealift swim platform that has worked well for the 4 years that I have had my SeaRay Sundancer 350. I am on a trip right now and when I tried to turn it on the switch no longer illuminates and the controller does not work. I can hear the solenoid clicking but does not seem to be...

That’s great - good job on thinking that through. I’m still scratching my head on why helm or splicing into the line would matter. Happy to hear someone else got it to work.

I have seen this diagram floating around the web but not sure where it comes from. I did a search and can find it a bunch of places but not in an actual manual.

Even with the genset not running you will still see battery voltage, genset hours, and the “Kohler” name on the screen if everything is working right.

That’s correct. I went straight from the genset to the hub and did not use those cables. For that second cable I don’t believe what I have is a terminator. I’m pretty sure that it’s just a dust cap cover. And that sounds right to me too because there would instead be a terminator on each...

Cn02. And my software version is 3.12. If you can’t get it to work then let me know what your SN is as well. As long as your genset is ON (front display is powered) then it will work on the Vesselview.

These 2 pages in the service manual cover it. I tried to attach the entire manual but it is too large.

You should be good. If your genset is 3008 vintage then I would expect your serial number (and hence software version) would be high enough. The number that is listed in one of the above posts is in the 205Xxxxx region and mine is in the 210Xxxxx region which I would expect yours would be too...

Hope this helps: 1) my hub (shown in one of the additional pictures before that cable was installed) is directly below the Vesselview and steering wheel. I have circled the door that opens that gives me direct access to it. If you can’t find it then just trace the Vesselview cables back and...

Sorry all for the slow reply. I had to get a coupe of pictures together. The first picture shows the J19 connector on the 5ECD. In the pic it is connected to the cable that Searay had installed at the factory but not connected for reasons that still escape me. It is on the backside of the...

There is only one Generator page on the Vesselview. I noticed as well that oil pressure was blank. Only a guess but I’m thinking that I probably only have an oil pressure switch rather than a sensor. Or that Koehler decided not to output the data. I can’t claim to have done anything super...

I know this post started 5 years ago but I’m happy to report that I was successful in getting this to work last night!!!! I have a 2008 Sundancer 350 DA. On my boat it was almost too obvious in the end. The P19 connector was hanging out the back of my 5ECD genset. I noticed that I had a...