Ah… I was such a babe in arms back then!
Here’s what I had to do:
I had a new transformer installed. It switches from 50 amp to 30 amp.
If I am plugged into 30 amp. I don’t run the 240 volt systems. Should I need them I fire up the gen. set. (That is mostly heat pumps.)
I have a post with two...
Thanks, my next step will be replace the o
rings. May be a days, however. I discovered I contacted the Covid virus. I feel better if I’d been hit by a truck.
Again, I come to you experienced Searay owners for help.
My aft vac u flush head generator cycles every ten minutes for ten seconds. I have replaced the duck bill valves and the large washer that Carrie’s waste into the generator. The plunger on the generator does not show signs of wear.
So...
My fuel gauges aren’t work correctly on my ‘05 - 40’ motor yacht. Probably time to replace the sending units. They cannot be changed out in the engine room. Not enough clearance from the top of the tank to the floor above.
When I had my carpet replaced I noticed about a 5” circular cut out ( in...
I discovered a little corrosion on my forward stateroom shower drain. I want to replace it before it gets worse. So, anybody know how the fitting is connected to the drain? And where I can find a replacement?
Thanks in advance!
Ted
When I pump out I refill the tank with fresh water and pump again. This seems to keep the float moving correctly. Also, I generally pump out at 1/2 full when I can.
Problem solved!!! The wire harness was loose coming out of the smart craft display!
THANKS TO ALL OF YOU!
If your ever in the Seattle area I’ll buy you a beverage of your choice. You saved me the 130.00 that a marine electrician would have cost! This site has been invaluable.
I have a 2005 Sea Ray motor yacht.
The analog gauges are frozen! Even when shut off the batteries, they don’t move.
The engines are Cummins diesels and digital display works fine.
Any thoughts before I call an electrician?
Thanks!
Ted Christensen
Hi
Anybody know what Shurflo water pump replaces 2095-233-234? It’s on my 40’ 2005 motor yacht. Water pressure in the forward head, sink and galley is slow. So, the plan is to replace the pump and actuator but the original pump isn’t made anymore.
Thanks!
Ted
I have searched through several posts and discovered that the laminate used for my ‘05
40’ motor yacht was made in Europe and no longer made. I have also contacted Restoration Marine (they’re great BTW) and they sent samples. Unfortunately, not a match. Anybody been able to find a match for...
This really helps! Which way we’re you standing to rotate the cover? Towards to bow or stern. In other words which way is counter clockwise?
Again, thanks!!
I own a 40’ Searay motor yacht. 2005 aft cabin. Anybody know how to get to the wiper motors? Where are they located. How to access?
Any help would be appreciated.