On the way home yesterday my starboard throttle level would only advance half way??
Question
Cable bad ?
Throttle linkage problem at helm?
Problem with throttle box. where do I start???
I’m replacing the rubber screw cover on my windshield. Does anyone know which way the rubber goes in the track?
Does the square end go on the bottom or top of the track. Which side goes on the bottom of the track?
Can I take all may heat exchangers off for the winter and leave them off so I May rebuild / clean over the winter at my
leisure?
Will the engines be ok during the winter?
2000 410 express salon bilge pump tripping breaker after 30 second. I put in a new 2000 rule pump and new float switch. Exactly what was in place and still trips breaker after 30 second. Is this normal? I decided to clean this area that’s when I discovered the breaker popped. This pump is under...
Looks like I have a pin hold leak in my starboard tank. Found a little fuel dripping from under the tank. Going to be a big problem I would assume. Any ideas?
Have a cruisair ac unit. SMX control panel blinking all over the place. This has happened before but usually clears up after a day or two. Anyone know the cause.
I have 2000 410 express with bunk beds on starboard interior. There is a sliding door that closes off the bunk room. Has anyone ever repaired the top roller on the sliding door? I have one that the roller came off the door, it has 4 screws that you can not access. Can you access the rollers...
Has anyone who has an 410 express with a 24” Thomson DM 12 series to lift the entire floor replaced one? If so who supplied it?
actuator is 24 inch
Dynamic load 1500lbs
Static load 1500lbs
Went to Walmart got the last 5 gallon buckets Rottella oil. And they don’t know when they expect the next shipment. Went to West Marine to buy antifreeze for the engine system I cannot believe it’s 7.99 a gallon for -50 below antifreeze what the hell.
I replaced my tank fuel senders but don’t like how the gauges read.
Shows 1/2 tank and only takes 60 gallons. Should be 83 gallons. tanks are
167 gallons each. I purchased the ones from Florida marine tank who made the tanks.
167 gallon Florida marine tank diesel
Sender model Prime instruments...
Looking to have my fuel polished. I have been quoted a price of
180.00 set up
100.00 hour to polish
Estimate 260 gallons to polish. I put app
100 hours on cat 3116’s a season.
Didn’t like how filters racors looked in the fall.
Is this a decent price?
I’m looking to replace my intake hoses on 3116’s 1999 410 express. I swear the photo I took this fall said MPI 2”. My eyes may be getting bad. Manual shows 1.25” I’m wondering if the 1.25” is for gas engines. See attached photos. Any help will be Appreciated.