Search results

Thanks for getting back to me - Agree with your comments above. Piping in some more fresh air from the outside would be good, but the question is how to do it without compromising seaworthiness and aesthetics. We are in the Bahamas now so I have put this on the top of my list when we return...

Can I assume that no reply means that no one has done any improvements to improve airflow?

Hi - I have a question for Sedan Bridge owners (2006 style). As you know the only way to get fresh air to flow through the boat at anchor is opening the hatch in the master stateroom and opening the sliding glass door - this doesn't do a very good job in warmer climates when the sun is...

Hi Carter, Yes, if you could send some more pictures that would be great! Also, do you know who fabricated it? Thank you, Ralph

The picture below shows a 175 Watt Semi-Rigid panel in the middle with a 55 Watt Semi-Flexible on either side. The Semi-Flexible panels are held down with 3M VHB tape. The 175 Watt Semi-Rigid panel slides into two aluminum extrusions on either side. I put a "Z" extrusion across the front to...

Hi, We have a 2006 52’ Sedan Bridge. I have mounted some flexible and semi flexible solar panels to the bridge roof for a total of 540 Watts consisting of 1 - 175 W , 1 -70W, and 6 x50 W panels. The number of small panels is due to the topology and features of the roof. My question to the...

Hi, We have a 2006 52’ Sedan Bridge. I have mounted some flexible and semi flexible solar panels to the bridge roof for a total of 540 Watts consisting of 1 - 175 W , 1 -70W, and 6 x50 W panels. The number of small panels is due to the topology and features of the roof. My question to the...

Hi, We have a 2006 52’ Sedan Bridge. I have mounted some flexible and semi flexible solar panels to the bridge roof for a total of 540 Watts consisting of 1 - 175 W , 1 -70W, and 6 x50 W panels. The number of small panels is due to the topology and features of the roof. My question to the...

Thank you - Just did and they told me that it is proprietary to Brunswick / Searay so I need to purchase through them -

I have a 2006 52DB with MAN 2876 LE 405 engines. One of my tachometers has failed and I need to find a replacement (picture below). The tach is made by Medallion Instrumentation Systems. The description and part number on the label is: 5 In Tach, 0-3000 RPM Port 6742-16000-01 Any...

Thanks for your reply. I have seen a lot of small ones on line but have been unable to find one large enough. I am looking for one approximately 18" tall. If you have any thoughts of who may carry large ones that would be great. If not I may have to custom fabricate one. Thanks again, Ralph

I have replaced my anchor with a Vulcan 40 - Boat 52' Sedan Bridge. The tip of the anchor can come close to the bow when raising it into place. I have seen some boats with nice stainless steel bow protection plates. My question is has anyone with a 52db added one and if so, where did you buy...

Thanks everyone!!

Hi, I have a 2006 52' sedan bridge with MAN engines. I removed the props to have them tuned up and forgot to mark which one (L or R) goes on the port side and starboard side. If anyone knows I would appreciate it. Thank you, Ralph

@ttmott - Thanks for your post - very helpful. A follow on question based on your experience with this. If I want to ability to have the Sirius Marine Weather connected to my MFD at some point in time AND have the Sirius music available through my fusion now, it sounds like the best option may...

Thanks everyone - makes sense!

Thanks for the reply - @Mauler34Rod - I did not see it in the parts manual, however, it is shown on page 6.8 of the owners manual (item B). See image and picture below: @Wylie_Tunes - The amp is still being used with a Fusion radio on the bridge with independent bridge and cockpit speakers...

I have a 4 channel 100W marine amplifier part number EAA046B. It comes stock on a 2006 52DB. Does anyone know where I can download a manual for this Amp? Thank you, Ralph

Thanks - If I can locate a matching RH prop I'll buy it. My concern is if someone advertises a set they usually don't want to split it up.

I am looking for a spare set of Hy Torq nibral 28” x 35” props for a 2.5” shaft. Thank you, Ralph