Search results

Thanks, but thought it was not possible when looking at the sump drain. Will re-look. Thanks.

Thanks. Will try that.

With regard to the shower drain in port head... the shower is slow to drain and want to remove drain fitting to snake out. Does the drain pop off or how do you remove? Thanks, Dave

Without thermostats. Leave on 24/7 year round when able to.

I installed 500W Wolverine pads on QSM11s on the side of the pan. Been installed since 2014. Trick for clean install is to cut piece of cardboard 1/8" wider than the pad. Spray Zip Strip paint remover on the cardboard and place on the spot you want the pad. Wait and remove. Makes a perfect...

if the same as a 2003... Maxumhardware.com 419-308-4990 part 750-10-120-A1A1. Replaced mine about 4 yrs ago. Dave

Thanks, Peter G for the detailed description and photos. Will check this weekend for those drain holes on port and starboard. My floor seems to be drying out now that the a/c is draining. Thanks.

I found the part number in Sea Ray parts... 1426857 which is a Rule 800 GPH Shower Drain System. Rule's old part number is RUL 98A which is obsolete. The new design and close replacement is the RUL 98B, but the input ports are a little bit different offset and not sure my hoses will reach or...

I found the part number in Sea Ray parts... 1426857 which is a Rule 800 GPH Shower Drain System. Rule's old part number is RUL 98A which is obsolete. The new design and close replacement is the RUL 98B, but the input ports are a little bit different offset and not sure my hoses will reach or...

Quality time... you were right. A/C drain line is clogged. Assuming it is coming from there. the plastic three hose manifold it attaches to on the outside of the drain box snapped off for the A/C drain, so just dripping into bilge. But it is clogged solid. Any idea where to get that plastic...

Thanks, mquiet and quality time. I will check for both areas next time I am down at boat. Appreciate the suggestions.

I have been trying to find the source of water entering the salon and wetting the carpet by the door. It happens after a rough ride when spray is hitting the port side or after washing the boat. Suppose rain also. I have tried to hose boat with helper and look for water in engine room looking up...

Apologize, Quality Time. I did not realize this was a new stand alone post. Thought was the 480 forum post. Didn't mean to hijack. will post over there.

I have been trying to find the source of water entering the salon and wetting the carpet by the door. It happens after a rough ride when spray is hitting the port side or after washing the boat. Suppose rain also. I have tried to hose boat with helper and look for water in engine room looking...

Thanks, everyone. Appreciate the help. Dave

Thanks ttmott and techmitch. I do have jumper cables on board, so attach one end to 4 and "touch and hold" on 1 while she cranks, then let go when she lights? Assuming will be a spark or two. Just want to be prepared if I need to do and what to expect. Thanks

Cod....Thanks. Assuming a hefty gauge wire and obviously only momentary until it lights?

See photo of starter and attached solenoid. sorry upside down. How would you jump the solenoid? Thanks, Dave

No change if hold down the "emergency start" switch. Want to know how to jump the terminals. I will try and post picture.