Search results

Just got scammed by a member on eim keypads So disgusting that people are getting taken advance of I will post more details as this unfolds This is a great website full of info BUT i will never purchase anything here again Sea ray form needs to work on scammers on this site Damn I...

I hate to say it but I only had 119 hrs on my kolher 5ecd. Over 50 hours labor and 800 dollars in parts still could not get it to run with out shut down Fix = new westerbeke efi Not worth throwing money at these units in my opinion

This is a scam Don't reply to this Bitch

Yep had to remove my starboard exhaust too Hopefully start mine in a few weeks I'm excited

I will send you some next time I'm at the marina

The switch over is not bad Make sure new gen is back far enough for hatch lift cylinder to clear Fuel line is more then long enough House power wires reach Need to solder new ends based on voltage Need a exhaust elbow coupler and hose to muffler Biggest issue was raw water inlet Need to...

Great to hear I havent started yet as the boat in not quite ready for the lake The one button for starting and 1800rpm Can't wait for that first cup of coffee on anchor

Hello skybolt I ended up selling my Kohler for parts I bit the bullet and bought a new westerbeke efi unit Cheers Ryan

Did you sell this stuff? Thanks

Hello looking for a starboard only switch pad. Looks like the same as my 340 Would you seperate? Price for one Price for complete set up? And reason for selling , did you upgrade if so what did you replace with On the fence what to do with mine Thank you Ryan

Yes it is way to light for this boat but yet it's rated for the wheight . As far as insurance and permits I was completely legal.for a 4500km trip I will be selling this trailer in the spring on searay fourm. And other places It would be perfect for a fountain or smaller beam boat. Would...

Asking 1,000 cad Need it out of my garage Thanks Ryan

Here a go Safe vs sketchy

Have a 5ecd kolher generator out of my 2006 340 Sell for parts only but could probably be running again in the right hands with some overpriced spare parts Gen had loc code and shut down after 10 seconds when I purchased it. After hours of troubleshooting and parts this still did not fix...

I gotta chime in on this one I bought a 2006 340 4500km away i bought a trailer that was rated for the weight close to the boat. I have a new f450 ford that's insured for over 32,000 pounds i also hold a Commerical drivers licence. Ok so we get to the boat it's dry docked. I looked at it It's...

My worm gears are stripped on mine I live in Canada I will take them if they work well Let me.know best way to get them Probably ups And best way to pay you Been on the form for a while but have never bought anything Also looking for starboard eim for my 06 340 if you have any leads...

Thanks yendor I have had a lot of feed back from members here with advise on what they found I have installed new impeller cleaned fuel system checked fuel pressure new injector cleaned heat exchanger changed map and voltage reg tested stator Tested every sensor and coils with instructions...

Are these still available ? Thank you Ryan

I have a 2006 kohler 5ecd with 115hrs on it. I belive I need a adc 2100 module but can't justify spending over 2 k usd on this. I looking to replace with a westerbeke 5 with a carburetated motor. please let me know if you have something available for sale Sincerely Ryan

Ok long story short due to can bus between adc and engine ecm I can not bypass this as thought I have tested every sensor fuel pressure and replaced injector I about 99 percent sure my problem is with the adc2100. Not sure if anyone might have a good used one I could get I can't justify...