Search results

Hello - I have a significant water leak around the swim platform rub rail. From inside the engine room there is a steady stream of water coming in from four of five areas that look like screw holes. The leak only happens when the boat is underway at speed, and not while sitting in the slip or at...

I've been working on the boat to get her ready for the season before she is launched in the next few weeks. When I plug it in directly to shore power to charge the batteries and run the lights and stereo, I can hear a loud humming noise on the Starboard side of the boat. Upon inspection I have...

I have a 1999 380 Sundancer. The engine vents do not have a screen, and the birds are making themselves a home. Does anyone know if Searay makes vent screens, or has anybody manufactured any?

Used Weaver Davit system - $150 plus shipping. Only what is shown in the picture. The rubber pads for the dighy and mounting screws to the swimplatform not included.

Marinco Single 50A Male to 30A Female cord - $75 plus shipping or pickup. Marinco Single 30A Female to 15A/110V Male cord - $60 plus shipping or pickup ( 2 available ) I have pictures available.

I'm looking to purchase an RL80C Plus to combine my radar and GPS into one unit. I currently have two units which makes the dashboard look cluttered. Please contact me if you have an RL80C Plus for sale in good working condition. Thanks, Gus

Last May I had 2 new carburators installed with tune-ups ( plugs, caps, rotors and wires ). I also replaced the ignition modules and coils on the motors ( paid the marina dearly - over $4K ). My problem is that my Starboard motor consumes roughly 5 gallons of fuel per hour more than my port...

I have a 97 Dancer 330 with 454 V-Drives, carbs, RWC engines. I sent both carb out to be rebuit by a professional company. I installed carbs and.. Starboard - motor idles fine and seems to run fine at cruising speed, but 10 -15 minutes of cruising the motor starts to lose power and shuts down...