Captain Don
Member
Could anyone tell me if the fuel lines from my tanks have any check valves installed? I can't see them or get at them without tearing apart the aft cabin floor. Point being, I want to disconnect the fuel intake lines from the selectors and blow compressed air down into the tanks to agitate the gasoline, this to mix in the E-Zorb for E-10 Fuel. This is according to E-Zorbs directions.
I cannot get an air line down thru the Fills, around corner elbows, etc. I have diluted the required amount of E-Zorb with 2 gallons of gasoline and put this mixture into each tank, It's almost like a glue consistancy, I have diluted it somewhat.
Has anyone ever had any experience with this, or any other ideas how to aggitate the fuel? Boat is out of the water and tanks are full and have been treated with Racor fuel stabilizer, I had forgotten to put in the E-Zorb.
Any replies are appreciated. (1988 340 Sundancer Twin 7.4's)
Thanks, Captain Don
I cannot get an air line down thru the Fills, around corner elbows, etc. I have diluted the required amount of E-Zorb with 2 gallons of gasoline and put this mixture into each tank, It's almost like a glue consistancy, I have diluted it somewhat.
Has anyone ever had any experience with this, or any other ideas how to aggitate the fuel? Boat is out of the water and tanks are full and have been treated with Racor fuel stabilizer, I had forgotten to put in the E-Zorb.
Any replies are appreciated. (1988 340 Sundancer Twin 7.4's)
Thanks, Captain Don