Power Trim Solenoid Sea Ray 310 2001

Hi All,
Sea Ray 310 Sundancer 2001 Twin Diesel Mercruiser D4.2L with Bravo 3 outboards.
As I am new to boating and this is my first season with the Sea Ray 310 and loving the boat.
I had a problem when I could not put down my starboard power trim it was just clicking, so after further investigation I found the solenoid was faulty so I replaced it and I had full movement up and down of the starboard side bravo 3 outboard when the button was pressed but the starboard side trim gauge only goes half way down from fully up. Is there any way to calibrate this or have I done something wrong?

Thank you very much for your time.

If you look at the trim senders on the side of the drive one is to set the drive limit and the other to adjust the trim gauge. Don't touch the one that says limit! The other says switch I think and you just loosen the screws and turn it slightly to adjust. You just have to wait until you're on land to do it.

Brite Idea said:

If you look at the trim senders on the side of the drive one is to set the drive limit and the other to adjust the trim gauge. Don't touch the one that says limit! The other says switch I think and you just loosen the screws and turn it slightly to adjust. You just have to wait until you're on land to do it.

Click to expand...

Many Thanks Brite,
I am looking at getting her out of the water middle of March for a clean and polish. I will take a look then.

Thanks again for your time.