Power Trim Solenoid Sea Ray 310 2001

Discussion in 'Sport Cruisers' started by JimMac, Feb 12, 2019.

  1. JimMac

    JimMac New Member

    2
    May 12, 2018
    Sea Ray 310 Sundancer 2001
    Twin Mercruiser D4.2L D-Tronic /Bravo III Drives
    Hi All,
    Sea Ray 310 Sundancer 2001 Twin Diesel Mercruiser D4.2L with Bravo 3 outboards.
    As I am new to boating and this is my first season with the Sea Ray 310 and loving the boat.
    I had a problem when I could not put down my starboard power trim it was just clicking, so after further investigation I found the solenoid was faulty so I replaced it and I had full movement up and down of the starboard side bravo 3 outboard when the button was pressed but the starboard side trim gauge only goes half way down from fully up. Is there any way to calibrate this or have I done something wrong?

    Thank you very much for your time.
     
  2. Brite Idea

    Brite Idea Member

    137
    Nov 5, 2011
    Long Island, New York
    270 Sundancer 2000
    twin 4.3 TBI Merecrusier Alpha Gen II counter rotating drives
    If you look at the trim senders on the side of the drive one is to set the drive limit and the other to adjust the trim gauge. Don't touch the one that says limit! The other says switch I think and you just loosen the screws and turn it slightly to adjust. You just have to wait until you're on land to do it.
     
  3. JimMac

    JimMac New Member

    2
    May 12, 2018
    Sea Ray 310 Sundancer 2001
    Twin Mercruiser D4.2L D-Tronic /Bravo III Drives
    Many Thanks Brite,
    I am looking at getting her out of the water middle of March for a clean and polish. I will take a look then.

    Thanks again for your time.
     

Share This Page

Show Sidebar