Happy Thanksgiving.
Looking for some recommendations on a canvas shop to have a custom mooring or bow/cockpit covers made on a 2005 Sundeck 240. Would like something that will work with my bimini in the slip.
Close to Central PA Harrisburg / Lancaster areas but will drive for a good...
Good morning. Need a recommendation on a reputable dealer or mechanic in the central pa area. I will drive for a good place that will do the job right and communicate.
Long story short, just purchased a new to us 2005 Sea Ray Sundeck 240. It was previously used at times in saltwater and...
Good afternoon. Haven't posted in a few years, but just bought a new to us 2005 Searay Sundeck 240, so back to the Searay family after years with a FourWinns.
This afternoon I replaced my dash panels with new units from FP Marine. I needed to disconnect the trim tab switches from the back...
Very cool picture. Not sure if anyone here follows Top Gear UK but the USA team had one of their vessels in a race against a car on the new episode last night. Those boats are incredible. Fully carbon fiber and the fixed sail is bigger than a 747 I think they said, I could be wrong, but very...
Link provided in the above post works perfect. It is a nicely laid out site that makes donating very simple. Here is for a quick recovery to great guy that would do anything to lend a hand to someone else.
I will check my SELOC manual for you later when I can get to the shop but I believe there is a write up on servicing these. I would think parts should be readily available as they are very common. At the least, it is a hydraulic ram, worst case you could take it to a hydro shop that deals with...
+1 on the LED upgrade. What an improvement. WM carries them in stock, just picked one up myself. They do also have an assortment of replacement lenses.
Good morning all. I am planning on replacing my existing PAR-Mate water pressure pump due to excessive noise when running and at idle and very low pressure. I could rebuilt but decided to just upgrade to a new unit and replace all fittings. My current model has a 2.5 GPM rating. I have no...