Recent content by msw1382

  1. M

    260 Sundancer Thread.........Comments questions and answers

    Great idea! I always wondered where the water was coming in from. This year, just before putting it in the water, My wife filled the bilge to make sure the pump worked. Happened to be on the ground and saw water dripping out of the transducer. Mystery solved.
  2. M

    260 Sundancer Thread.........Comments questions and answers

    Yeah, may be the best bet. My goal for next year is a dry bilge. River water in pgh stinks
  3. M

    260 Sundancer Thread.........Comments questions and answers

    Has anyone removed their stock transducer? I've gone aftermarket and the stock one is leaking pretty regularly. I'd say bilge pump runs once every 1-2 hours. I'd like to rip it out and seal it but not sure the best path to take. Thanks
  4. M

    Wet Carpet, 2005 Sundancer 260

    Hey Scott, I had the SAME issue! Went through and replaced sink lines and even tore out the fridge and replaced it with a new one. Turns out it was from the small window on the Port side just above where the sink is at. It was open a tiny bit. Water would flow around the seam, down the...
  5. M

    2005 Sundancer 260 Cover?

    I'm looking for a cover (tired of getting the boat wrapped) for my 2005 Sundancer 260. It looks like I will be coming up short from the searches i've done and even Carver didn't have a recommendation for me but before I throw in the towel, I wanted to see if anyone out there had any...
  6. M

    Kohler 5ECD generator trouble shooting

    I actually just went through this. The heat exchanger is on the top of the generator. If looking at the generator from the impeller side, the intake is on the left and the exit is on the right. Go to home Depot, get a few feet of tubing (I don't recall the size) with a barbed hose...
  7. M

    Kohler 5E Generator Water Flow

    One other thing... Ran it for about 3 minutes and the water coming out was never over "Luke warm".
  8. M

    Kohler 5E Generator Water Flow

    Hey everyone... We recently had the boat out on the water and noticed the generator was not expelling any water at all out of the exhaust. I removed the old impeller and found that every single vane was gone. Replaced with a new one and back flushed the heat exchanger. After back flushing...
  9. M

    260 Sundancer Thread.........Comments questions and answers

    I just realized I wasn't clear on my question, sorry! For the trim, yeah I know what i'm up against there. My cable question was related to the steering\throttle cables.
  10. M

    260 Sundancer Thread.........Comments questions and answers

    Hi everyone, new to the forum. My wife and I bought a 2005 Searay 260 last year and spent most of the season getting used to it. Now that we're approaching time to put it in the water I want to do a few things... Steering\Throttle cable replacement Fix Trim for outdrive (fun i know) - Hope...
Back
Top