Looking for some help. My port engine hour meter stopped working on my tach today. Everything else on the tach works fine. Is there somewhere on the motor it’s getting its signal from? 2003 mechanical version. Thanks
I would read this and find out if the props were tuned for the power output. I have a friend with issues described on this motor because of that. I own the 450 Diamond C before the E version.
https://www.sbmar.com/articles/propping-cummins-6cta-8-3-480ce-vs-430450-diamond-engine/
The cockpit teak table comes with 2 pedestals. Use the short one. Then there should be a "platform" to fit on top of the table with straps/snaps to snap under the existing cockpit cushions. It will have Velcro on the top for the cushion to sit on. I had trouble with the screws under the table...
Farrbar,
I have a 2008 350DA for sale in Minnesota. Exceptionally clean boat. It might be worth your transport fees. Here is my CL link. http://minneapolis.craigslist.org/wsh/boa/5614896739.html
I dealt with the same issue for 2 seasons. Finally gained access to the tank/pick up. The PVC elbow going into the tank with the pick up tube had a small crack in it. Replaced it, and it runs like a swiss watch now.
The vacuum-flush toilet system is a entirely separate system and has nothing to do with the fresh water faucet system. This system sucks the water and crap out of the toilet and deposits it into the holding tank. It also is only a 12V system. If I remember correctly from my 300DA, both the...
Ididntdoit, is spot on! I've owned both and love 08 350/370. Hard top, walk through windshield, wider beam, built in grill, helm seating that swivels around, etc... All options you will not get on the 340.
I was getting the "CO5" alarm on the same generator. Just alarm and not shutting down. Replaced the sensor module that JimG is talking about and the alarm went away. Its a little circuit board and what "looks like" a AA battery attached to it. It is located behind the control panel on the...