Search results

Does anyone know where the inverter is mounted on a 400 SLX? And what AC electrical outlets/components it powers?

Thanks, I found one at West Marine. Also, I'm thinking of just removing the cylinder from the top bracket and replace it with the new cylinder. any thoughts on that.?

Tom, Please see attached picture. By feel, there are 4 raised rings. The picture clearly shows 3 but a 4 ring is there, barely visible. Regards, Terry

Tom, Please see attached picture. By feel, there are 4 raised rings. The picture clearly shows 3 but a 4 ring is there, barely visible. Regards, Terry

Okay, but it will be 2 weeks until I'm available to get picture. Thanks, Terry

Tom, Please see attached picture. Terry

Awesome! Thanks again

Thank you. By the way, I plan to do this without pulling the boat out - that alone will cost $600. The ram/mount is above the waterline by about 4 inches, so I'm pretty sure i can remove it, keep the surface dry, and reattach a new ram/mount on the outside. Guess it depends on how long the...

Thanks Tom. I will be back at the Lake this Friday and will get a picture to send. I appreciate the help. Terry

Thanks, but the piston or ram separated from the cylinder. I'm thinking I need to replace the entire hydraulic arm (cylinder and piston).

The piston or ram separated from the cylinder. I'm thinking I need to replace the entire hydraulic arm (cylinder and piston). So I was wanting to see if anyone has replaced it, before I order the parts.

Has anyone replaced the hydraulic arm on the trim tabs?