Search results

  1. F

    Worn cable (steering?) on 2010 Sundeck 220

    Hello, Per the attached pic I discovered this worn cable, circled in red near the engine bay. The rear passenger cooler/storage screws over this and the plastic drain plug pushes hard on the cable, creating the wear. Is this part of the steering cable? And should I replace? Thank you
  2. F

    YKK zipper repair?

    Per the pics, the top of the zipper that holds the handle on popped off. Can I just snap a new little cover on that holds the handle in place? Where can I get these? Not sure size but pretty big canvas zippers. The cover flew in the water but I have the handle. It will be tricky to have to...
  3. F

    Canvas loop snap repair/kit?

    Hello, Per the attached pic I'd like to repair this loop snap myself. I don't see any sort of kit on Amazon and or West Marine. Appreciate any advice. This is on the back of the boat and now flapping a bit. Thank you
  4. F

    Airmar Smart Transducer not working

    Hello, I have an Airmar part number 888828A21 that isn't reporting depth anymore. The screen just shows zero. The temperature is working. This is in a 2010 Sundeck 220. I've attached a couple pictures. How far back to the wires go, clear to the helm? Or is there a plug nearby in the...
  5. F

    Oxidation Revisited

    I've read the majority of oxidation solutions here, watched YouTube videos, researched etc. and decided to buy a Porter Cable orbital, Hexlogic pads and used Starbrite premium cleaner wax with the orange cutting pad. This hardly phased the topside oxidation you see in the picture. I made...
  6. F

    2010 220 Sundeck throwing engine faults

    Hello all, I have a 5.7 L Merc with 419 hours in the Sundeck. Early this season I was occasionally getting a fault that would put the engine in guardian mode. The DTS display would say "Engine throttle level not operating properly". After shutting batteries off it would reset and run fine...
  7. F

    Alternator output on 2010 Mercury 350/Sundeck 220?

    Hello, I'm adding some additional LED xmas lights to the boat this year for parades etc. You can see in the signature below I have two long runs of LED lights that draw about 10 amps total. These have been fine for long runs including idles for extended periods; 6 hours. I want to add more...
  8. F

    SeaRay parts? table with mount and arm

    Hello, Anyone know of a great SeaRay parts department that has good pricing, help and shipping etc.? I need to put in a table in my 220 and I'm not super crazy about my local SR dealers. Thank you
  9. F

    Dometic toilet leaking at level indicator

    Per the pic, the toilet is leaking at the seam. And the leak is obviously waste. It's very slow but needs to be fixed. Will I need to replace the whole thing? Any chance Dometic will replace? It's five years old... Appreciate any advice.
  10. F

    Plastic angle brackets?

    Any idea where I can buy these? I'm putting in a shelf and need some more of these. Thanks!
  11. F

    Garmin chart plotter 547 NMEA engine data not in all screens

    Hello, I recently installed a Garmin 547xs along with the Mercury NMEA Gateway and network. The data is coming over, as you can see in the data only pic I have the engine data coming over. However in the map view, some of the engine data isn't coming over: RPMs, fuel flow and level. I've...
  12. F

    Shield drain wire on NMEA backbone power?

    This is from a Garmin NMEA 2000 backbone power supply. I understand the red goes to positive and black ground. What do I do with the shield drain wire, shiny silver? Thanks
  13. F

    BBQ installed, thank you

    SeaRay forum, Thank you so much for all the info on stalling the bbq. I ended up drilling a little bigger holes in the swim platform, injecting resin, drilling out again with smaller holes, then using the 3M product I learned about here along with the resin technique. I debated putting it on...
  14. F

    Custom paddle board rack installed

    After multiple boat shows (talking to the tower rack people), and metal shop visits I finally found a shop to make the front tube attached so I can put my paddle boards up top. I made a jig out of plywood (the width had to be exact in order to fit on the existing tower) along with a bunch of...
  15. F

    Fender Locks?

    I'm thinking about screwing on some fender locks to get the lines off my cleats. The existing cleats are the retractable type on a 22 ft. sundeck and there just isn't a ton of real estate for both fender lines and dock lines. I think it would be much quicker to fender up too when coming in to...
  16. F

    "Flush" install to non-flush surface

    I'm thinking about mounting a smaller/5# chartplotter somewhere. In the picture, I'd like to get it on the right side just above the cup holder, surface mounted. This puts the controls within easy reach and screen easy view. The surface however is slightly curved. Is there some trim I can...
  17. F

    Making bed for two out of Sundeck

    Hello, We'd like to have the option of sleeping a night or two on our 220 Sundeck. In this picture you can see the folded out Sundeck. Perhaps I could somehow extend the flat are towards the bow or even in the walk way? Anyone done this? Any aftermarket option out there can get? I have the...
  18. F

    Can Garmin chart plotter connect to existing engine data/SmartCraft?

    Hello, I have a 22 ft. 2010 Sundeck on a fresh water lake. We're ready to venture into the Puget Sound and I'm looking at a chart plotter, pretty closely at one of the Garmin 5" GPS MAP. There are ports to inport engine data, NMEA. Any chance I can plug and play from the Mercury SmartCraft...
  19. F

    Seattle Opening Day this Sat 5/2/small boat access?

    Hello, Per the signature I have a 22 footer. Is there any way to see the crew races and parade without tying up to the log boom? That seems to be for the big boats with donations etc. I've been under 520 all winter long during the new bridge construction however it may be a mess with all the...
  20. F

    Wiring into existing dash switch

    I'd like to wire an led light bar into an existing dash switch. The switch is labelled 'accessory' and nothing comes on when the switch is turned on. There is wiring to the switch and I assume the hot end is somewhere in the boat. Where would this be? It's a 2010 Sundeck, 22 foot. I've also...
Back
Top