Search results

Nicely done, I ordered replacement caps and did the same thing only I used them for blowing out the through hulls and winterizing.

YES SO SAD TO SEE THIS! Glad all are safe!

I purchased an addition TV Mount base/receiver so the same TV could be used in the cockpit or at the helm. Will also feed an HDMI and use as an additional monitor when I update my electronics. This is the location chose at the helm seems to work pretty well. I may have an extension made so I can...

Waaaaaaait for me!

I modified the mount to route the 12volt wire through the stainless steel tube. I mounted a 12 receptacle inside the starboard side rear locker w/inline fuse. Ran shielded wire over from the receptacle over to the main battery buss on the house battery.

Running on Roku and a ATT Hotspot, chose Roku so I can stream through my boat sound system via bluetooth.

finished up the 12v dc TV Install. Pretty happy with the results.

I have seen a couple pics of 450EB with AC vents at the helm. Seems like some one once told me they duct air to the helm for the mid cabin. I have looked through my manuals and on Searays online resources but haven't found a schematic. Anyone have any experience with this?

I agree my buddy in the slip next to me has a 2000 38 SR Aft Cabin they do look similiar but I believe slightly shorter and installed inverted as I recall. Perhaps the larger aft cabins are the same. Below is a pic of the 2001 420 AC, looks spot on Searay 2001 460 Express looks a bit different

Yes it starts with a 3D scan and/or he could model it up manually if he had the part. Wonder if SeaRay would have/share their file? Furthermore THIS IS A BIG PART to 3D print. Not many shops have the ability to do this big of a job and the finished product would then have to be preped and...

I am on the boat this weekend and will snap a pic of the lower numbers as post accordingly.

He is pretty busy making custom teak tables in his spare time but I will gladly ask him if he interested in printing up another set and get you a price, I know they took a lot of material to print as I recall each one took 32 hours on the printer to get the best surface quality. You would have...

Yes 3 stateroom layout.....my hull numbers are SERP4828B001

Jim......lol you don't miss a thing, yes these are speaker pods on the front of my boat. My son and I designed and printed on his 3D printer.

yes just kind of a catch all space in the middle

Just received my new cup holder from Gripmate and put it to the test this past weekend. I have got to admit this has exceeded my expectation. Non skid bottom material with added velcro security strap and weighs enough not to take flight. Out all day up running 2200 rpm this thing didn't move...

I also have That table looks GREAT! Assuming you have some of finish on the table I doubt you could cover with epoxy. Most likely would have to take it back down to raw wood and then start the epoxy pours, even the slightest residual from previous finish could be problematic. Epoxy coat is...

Actually any water intrusion in this area will make its way forward(cockpit shower is directly above) to compartment beneath the black water tank. If you have ruled out other sources I would watch this area closely. This had me scratching my head for several days.

Jim that's the one!! I will drive!!

Yes that is the ground strap that I am referring to and it looks in tact. And yes lost the underwater exhaust, these things are made to break away pretty easy to avoid damaging the hull. Spring time boating on the Mississippi can be a bit tricky a lot of submersed objects floating down river...