Search results

Good day all. Long story short, when changing out my manifolds and risers to cure an exhaust leak it was discovered that the "replaced" manifolds were never done as indicated when the boat was purchased. With that said, my motors are 2006 inboard 5.7 350 Horizons with approx. 500 hrs. Where the...

Good day all. A problem has come up with one of my engines and I'm in the process of figuring out what's wrong and some input from everyone would be greatly appreciated. I have a 2006 Sea Ray Amberjack with 350 MPI Horizon motors, V drives (serial# range OW39000). There are approximately 525...

Good day all, I have a 2006 Amberjack inboard with the MFD flush mounted on the dash. While seated at the helm the shifter levers obstruct the viewing of the screen. My question is, are there shorter ones available? Or is there a company that can fabricate or modify the shifter levers. I believe...

Good day all. I've committed myself to replacing both fuel sending units with the "stem" type. In order to have the clearance needed to install them I have to move both the helm and companion seats. I started on the companion seat and found that the screws are bolts. I was able to remove the...

Good day all. I have a 2006 Amberjack 290. When I first start the engines I get the most accurate reading on the fuel gauges (also has SmartCraft readings that reflect gauges). During operation the fuel levels will fluctuate on both gauges. Sometimes even going to empty and knowing that I have...

Good day everyone. I hope you are all well and safe. I have a 2006 Amberjack. After winterizing the freshwater system, the hot water feed from the pump and the two cold water feeds from the pump are leaking. I've tried to stop the leak by pulling out the rubber seals, cleaning them and even...

Good day all. I have a 2006 Amberjack V-Drives. One of the high pressure steering lines is damaged and in need of replacement. Both ends are disconnected and all zip tie hangers that I can see have been cut. I’m only trying to remove one line. I've made some attempts to pull the line through but...

Good day all. I have a 2006 Amberjack V-Drives. One of the high pressure steering lines is damaged and in need of replacement. Both ends are disconnected and all zip tie hangers that I can see have been cut. I've made some attempts to pull the line through but there seems to be some resistance...

Good day all, with the boat on the hard it's time to address some issues. This is the first year with my 2006, 290 Amberjack. The previous owner had installed a Raymarine "Triducer" B774V. The problem is the installation is in the wrong location right behind one of the strakes on the starboard...

Good day all. Here’s a question. 2005 350 Horizon Mercs, V drives. Fuel rails and injectors have been replaced due to a service bulletin, that I'm aware of. Not sure about the pumps. Relay for fuel pump burnt a connection (pin 85). Replaced and started the motors. Did an amp test on the red wire...

Good day all. I have a 2006 Amberjack with 350 Horizon Mercs. My starboard motor turns over but will not start. When I try to start it I do not hear the fuel pump activate. I checked the connection and there is no power during start up. I unplugged the oil pressure sensor wire on the port motor...

Good day all. I have a 2006 Amberjack 290. This boat is new to me and I've only ran it a few times. I just put new cranking batteries and house battery in it(the batteries meet the required amperage). After running for a while I'll shut down the motors to drift or anchor fish. When I go to...

Hey guys and gals. I just got into a 290 Amberjack and found that the head's bowl has a couple of small cracks. I'm looking to replace either just the bowl or from the deck up. Found out that the original head is discontinued. My information up to this date is I would be good with a replacement...