1995
Gen starts but runs real rough,won’t come up to speed
I have changed plugs..oil..gov oil..fuel filters.. starting to think
It may be fuel pump or carb issue
Any thoughts on what else I may be over looking
Thank you
MKnupp
My 95 330 dancer was manufactured at palm coast Florida facility, after contacting great lakes about replacement canvas I was informed that the facility made changes to canvas after great lakes supplied original canvas. Anyone have any experience with ordering replacement from great lakes for...
i have a 1995 330 sundancer 7.4s with v-drives. no idea if shaft seals have ever been replaced . any body know how to tell if they are original seals, I don't see any hoses going to them for cooling, do they have a packing that can be tightened? also what would be the best replacement seals...
Noticed temp gauge rising quick, open engine hatch water spaying out of some hose? Not sure if it’s inlet hose or discharge house after sea water pump. Appears to be under front of engine 7.4 vdrive. Thanks in advance
5.7 mercruiser alpha drive. Spark plug on one cylinder blows off porcelain after running above 2500 rpm.. compression good , heads have been redone, new carb and fuel pump, timing is spot on....no clue as to why this happens, also no water in the suspect cylinder, temp reads normal... only thing...
Anyone know where I can purchase a set of 17by 17 3blade bronze or nibral props. 1.25 in bore ? New are 6 to 8 weeks lead time , and used are very difficult to find.
Thanks in advance.
Anyone know where I can purchase a set of 17 by 17 bronze or nibral props 1.25 in bore? Because of Covid everywhere I have checked are 6 to 8 weeks lead time .. used ones are harder yet to find. Thanks in advance
Can someone tell me how to remove props from inboard v drives. will I need a prop puller? always had sterndrives so this is a bit different I believe. thanks in advance!