Search results

got twin mercury 5.0 mpi with bravo 3 outdrives and one motor idles lower than it should i was seeing if anyone knows if it is a adjustment is on the cables by the motors or of it needs to be adjusted elsewhere. I looked on here and can't find anything about adjusting the idle

I just replaced the raw water pump on my 2006 280 sundancer. Do I have to prime the system or should it just suck the water from the muffs? The motor is a mercury 5.0 mpi. I just tried starting it with the hose hooked up to the muffs and no water was coming out I only had the motors running...

last year had a slight leak on my bravo 3 outdrive on the port side. This year had the bellows changed and got the boat back to my house and noticed oil leaking off the exhaust bellow on both port and starboard drives while the motors were in the trailer position. Lowered both outdrives down...

Just installed a new water heater in my boat and there was no check valve on the fresh water lines coming in or going out. I believe there is suppose to be one but I'm checking to see. And if it should be on the inlet side so the hot water won't work its way back to the rest of the water...

Looking for some info on the wiring on a bow thruster. I purchased the 280 last year and there is a separate battery under the cushions in the bow of the boat. There are no wires running to the battery to charge it i was told by the marina that i bought it through that the previous owner had...

I have a 2006 280 sun dancer. I have had issues with the water coming into the sump under the step but have been able to get the water out with a shop vac but with the boat sitting on the trailer right now for the next month until i will be able to put it in its slip for the summer I have been...